Models > 91193714020

91193714020 Kenmore Range - Overview

Get Parts and Repair Help for 91193714020

If you know the range repair part you need, you can browse the list of all parts on the 91193714020, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for 91193714020 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$49.62

Bake Element - Push On Terminals - 240V

This bake element is found on the bottom of the oven.

$12.60

Surface Burner Terminal Block Kit

Also known as receptacle.

$11.25

Surface Burner Terminal Block Kit

This kit includes the female contact with wires, terminal block and mounting clip.

$6.84

Burner Bowl - 8"

$5.98

Burner Bowl - 6"

$19.54

Surface Burner Switch - 8" - 2500W

$4.27

Rear Drawer Support

This rear drawer support comes with the installation screw. ***NOTE: There has been a factory design change and you must change both rear supports from side to rear.

$12.82

Oven Sensor

This sensor detects the temperature within the oven cavity.

$47.23

Broil Element

This broil element is found on the upper part of the oven cavity.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Bake Element burned out, bunt like a sparkler.

  • Customer: Brad from Bedford KY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 126 of 135 people found this instruction helpful
Ordered the part on Friday, got it on Saturday, very impressive. Be sure to unplug the range or disconnect the power at the breaker box before any repairs are started.

The lower (Bake) element is held in by 2 screws. Remove them and gently pull out the element to remove the power wires connected to the element. These wires are very short and ther... read more

The Bake-o-lite (Hard Plastic) block that holds the burners female connection in place had chipped away over time and wouldn't allow the male part of the burner to connect up correctly.

  • Customer: Robert from Mt. Vernon IN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 65 of 67 people found this instruction helpful
After unplugging the range I took the rear sheet metal panel at the top off with a nut driver to expose the wiring connections. The next step was to remove the single screw holding the old part in place. (under the drip pan) Once free I snipped the old part from the wires and then taped the new female ends to the old wires with black electrical tape. From re... read more

burner was shorting out

  • Customer: douglas from louisville KY
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 36 of 36 people found this instruction helpful
unplugged unit pulled it away from wall took off the backplates traced wire to plug replaced with part ordered very smooth operation. the most impressive thing to me was i ordered part on computer and it was at my door in 30 hours awesome. read more