Models > 91193607002

91193607002 Kenmore Range - Overview

Get Parts and Repair Help for 91193607002

If you know the range repair part you need, you can browse the list of all parts on the 91193607002, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for 91193607002 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$11.25

Surface Burner Terminal Block Kit

This kit includes the female contact with wires, terminal block and mounting clip.

$12.60

Surface Burner Terminal Block Kit

Also known as receptacle.

$6.84

Burner Bowl - 8"

$5.98

Burner Bowl - 6"

$19.54

Surface Burner Switch - 8" - 2500W

$12.82

Oven Sensor

This sensor detects the temperature within the oven cavity.

$26.25

Oven Rack

Sold individually.

$1.70

Screw

This screw is sold individually.

$4.27

Rear Drawer Support

This rear drawer support comes with the installation screw. ***NOTE: There has been a factory design change and you must change both rear supports from side to rear.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The Bake-o-lite (Hard Plastic) block that holds the burners female connection in place had chipped away over time and wouldn't allow the male part of the burner to connect up correctly.

  • Customer: Robert from Mt. Vernon IN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 70 of 72 people found this instruction helpful
After unplugging the range I took the rear sheet metal panel at the top off with a nut driver to expose the wiring connections. The next step was to remove the single screw holding the old part in place. (under the drip pan) Once free I snipped the old part from the wires and then taped the new female ends to the old wires with black electrical tape. From re... read more

The switches failed on both front burners.

  • Customer: Marc from Columbia NJ
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 42 of 42 people found this instruction helpful
Remove nobs from both switches.
Pull out the range (the hardest part).
REMOVE THE POWER PLUG FROM THE WALL
Remove 7 screws with nut driver and take off upper back panel.
Remove 2 phillips screws from front, they hold the switch brackets.
The new switches don't fit in the bracket so discard the bracket keeping the screws.
Removin... read more

burner was shorting out

  • Customer: douglas from louisville KY
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 36 of 36 people found this instruction helpful
unplugged unit pulled it away from wall took off the backplates traced wire to plug replaced with part ordered very smooth operation. the most impressive thing to me was i ordered part on computer and it was at my door in 30 hours awesome. read more