Models > 91193551991

91193551991 Kenmore Range - Overview

Get Parts and Repair Help for 91193551991

If you know the range repair part you need, you can browse the list of all parts on the 91193551991, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for 91193551991 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$8.16

Door Handle End Cap

This oven door handle end cap is used on both the left and right hand sides. Sold individually.

$4.27

Single Heating Element Support Clip

This metallic clip is used to help support the broil element. Sold individually.

$89.55

Oven Sensor

This sensor detects the temperature within the oven cavity.

$29.82

Hinge with Roller - Right Side

$40.76

Surface Burner Terminal Block Kit

This kit comes with the terminal block, mounting clip and wires.

$34.18

Hinge with Roller - Left Side

$2.36

SCREW

Sold Individually.

$29.04

Door Handle

$45.29

Broil Element - 240V

This element has push-on terminals.

$17.67

Oven Light Housing

Must buy bulb locally as per manufacturer.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven tempature was approximately 150 degrees to low

  • Customer: James from Austin TX
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers
  • 152 of 176 people found this instruction helpful
This repair is EASY if you know how to use an ohm meter. If not, seek help for this step.

SYMPTOM:
The oven (JKP27WOP3WG or JKP27WP3WG and many ovens like it ) was not getting hot enough. Verifying the cooking temperature with an typical oven thermometer, I was able to determine that the oven was cooking temperature was about 150 degrees t... read more

The right side hinge assembly broke. Replaced both sides

  • Customer: Frank from Pebble Beach CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 34 of 35 people found this instruction helpful
First I removed the door by lifting it off the hinge assemblies.

Then I removed the drawer to access the spring.

Removed the spring, noting which attachment hole was used.

Removed the hinge assembly with a Phillips screwdriver.

Replacef the unit.

Repeated for the other hinge assembly.

Note: it... read more

Oven would not heat to the correct temperature

  • Customer: Michael from Lawrenceville GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 32 of 51 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires read more