91161778790 Kenmore Range - Instructions

removed broken element and installed new element when received from UPS -very simple -

Following the repair video made the job very easy and quick, about a 5 minute repair. Wife says oven door never worked better. Thanks a lot for all your help.

It took longer to watch the video on how to replace the hinges than it did to replace them. Simple and easy. Video knocked it out of the park for ease. And now the oven door works great! thanks!!!! Video suggested if you're replacing one side do both, couldn't agree more.

I unscrewed the broken hinge, removed the tension spring and replaced the old hinge with the new one. total time 5 mins works great.

we just pulled out the burned out element but the one wire fell down the hole so my husband made a wire hook to get it back out .Plugged it all back in and we were good to go!

After trying a new bake element and not fixing the problem. Barrowed a tester to test parts. Power resistor bad.

Followed the instructions provided and they were very accurate. I also proved to my co-workers that I could repair it with no problems.

Remove the knobs on control panel. Removed a few screws. Remove wire fasteners from old part. Re-installed new part, re-fastened wires, re-installed control panel & screws, re-installed knobs. Tested burner on low, medium & high settings to confirm heat adjustment. Done!

easy repair. undo a couple fasteners, pull out wires, unfasten, put in new element, fasten, put fuse back in, fire up...works perfect. having pizza tonight!! thanks for the correct part and two day delivery.

Very,very easy. Just like the video described. Removed three screws. Released the spring and removed the old hinge from the slot. Slipped the new hinge in the slot,replaced the screws and reattached the spring. Job done! Great service!

2 screws located underneath of the control panel. Unplugged the stove first! Pulled the leads out of the old switch and plugged into the new switch making sure wires went to the same location. SIMPLE! It works as good as new

I did as the video suggested.....I cut the old wires and spliced new ones already attached to the new terminal block. It would have been nice to have some instructions with the parts as I expected one piece but had to connect the wires to the new block and the new metal cover. I was guessing a bit. Also, I needed to use the holder strip off my old part so that it displaced the new part back far enough to insert the burner connections. That meant finding a screw and nut small enough to allow the metal cover to fit on the block. But the burner works great. I've learned that any repair requires some ingenuity.

Once I watched the video I realized how absolutely simple the whole repair would be. The information making sure the little clips did not slip back into the oven was quite helpful. I saved a minimum of $150.00 by completing the task myself. Thank you. Joan

1. Google your appliance problem. 2. Watch whatever YouTube videos that are available. 3. Follow the excellent instruction provided by PartSelect.

took two screws out and unplugged wires. Had to curl up ends of element so they would short out. plugged wires back on new element and replaced mounting screws.