Models > 8351VS

8351VS Magic Chef Cooktop - Overview

Get Parts and Repair Help for 8351VS

If you know the cooktop repair part you need, you can browse the list of all parts on the 8351VS, or you can search by name or part description. You can also find your part by where it is located on the 8351VS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. We’ve also included any installation videos we have for 8351VS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the 8351VS [Viewing 3 of 3]

$15.25

Top Burner Igniter

This top burner igniter comes with a mounting bracket.

$24.70

Burner Head Cap with Spark Electrode

This is a black burner head with the spark electrode. NOTE: This part has been updated and there is no longer a gasket seal required.

$2.70

Screw

This screw is sold individually.

$78.54

Spark Module

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$2.70

Screw

This screw is sold individually.

$3.82

SCREW

$3.71

Igniter Wire

$15.89

Burner Knob

Sold individually. This knob accepts a D-shaped shaft.

$3.82

Frame Screw

Sold Individually.

$3.82

SCREW

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

gas burner ignitor failure

  • Customer: roy from East Providence RI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 66 of 75 people found this instruction helpful
Lift out sealed burner assembly rear of stove first while careully sliding to rear to disengage ignitor probes.Remove philips head screws from bottom sheet metal housing to expose bottom of burners Remove gas tube assembly screws and move tube away carefully.Unplug wires from ignitor.Remove screws for ignitor .Remove ignitor, I noticed that rust and dirt ha... read more

top burners on stove won't ignite ,no clicking noise

  • Customer: scott from centreville VA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 28 of 42 people found this instruction helpful
remove small panel on right side of stove,then un clip moduke and put wires from old module to new one.
Exact fit nomproblems. read more

Burner wouldn't start

  • Customer: Yury from Brooklyn NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 17 of 26 people found this instruction helpful
Make a quarter turn counterclockwise, disengage a burner head, disconnect 2 wires, connect to a new head, install turn clockwise.

That's it! read more