7WDT770PAYM3 Whirlpool Dishwasher - Instructions

Push and turn!!!

I had a common issue on many dishwashers, the final drain cycle was not draining but the pump was trying to turn. Also, the drain pipe was clean. This issue caused a burning smell, like a circuit board heating up. Half plastic smell, half electrical. I bought a replacement pump, followed the pump replacement video instructions from PartsSelect, and it was replaced in under 15 minutes without any tools.

I used pliers to pull the old clip out and pushed the new one in. Easy as that!!

I followed the Partselect video for the new installation. Very easy to follow which made new part installation extremely easy. Works perfect now!!!

Very easy

Unscrewed the old cap, replaced with the new one. It couldn't be easier.

Slid the holder into the protrusions on the dishwasher door.

removed old door gasket, cleaned gasket groove, and than started new gasket in both corners working my way to middle top of door, made sure gasket was in groove properly w/my fingers. problem solved

Installed new gasket and striker. By not pushing the gasket in all the way , as it is intended to, it stopped the leak. The gasket is made to push in partways or all the way. Worth the money!

Popped the old clip out, replaced with new.

I followed installation instructions from this site and all went well.

I first verified that there was 120 volt line voltage getting to the unit. I removed the outer door panel by removing the 10 torx screws located around the panel on the tub side of the door. Two of the screws are longer so note there location for reassembly. The door handle can now be removed. Pull the outer door panel away from the inner panel and remove the connector to the control board. Set the outer door aside. Remove the connector to the door latch.The latch is snapped in position at the top side. Pry using a screw driver to release. Snap new latch in position. Snap on connector, Reassemble door by first reconnecting the control panel connector. install plastic door handle. Mate door to inner panel. Note interlock tabs between outer door and inner panel near the bottom area. Install the 10 screws. The two longer screws are at the top holding the latch and handle.

Followed the video. It works perfectly. Used a small paint scraper to remove stubborn scale where gasket seats. Used steel wool on door to assist in removal of rough scale.

Remove the old door seal by pulling it out. Take the new seal find the center of the new seal by lining up the ends so they are even. Push the new seal starting with the center you just found at the top center of the machine. Push it in to the slot as far as it will go going both to the right and they to the left so it stays even. At the bottom of each end cut the extra on a angle. Use a screwdriver to pry to old strike out and push in the new one. Your done.

The cap fit perfectly-just screwed it right in to position. Turns out I didn't need the gasket.