Models > 7MWGD8800AW0

7MWGD8800AW0 Whirlpool Dryer - Overview

Get Parts and Repair Help for 7MWGD8800AW0

If you know the dryer repair part you need, you can browse the list of all parts on the 7MWGD8800AW0, or you can search by name or part description. You can also find your part by where it is located on the 7MWGD8800AW0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for 7MWGD8800AW0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$24.54

Lint Filter

This filter collects lint as it passes through the dryer vent.

$3.61

Door Catch

$22.75

Igniter Kit

This silicone carbide igniter with ceramic holder kit includes the 3" flat igniter, bracket, 5" wire leads, and the plug. Able to replace both round and flat igniters, this kit is ...

$25.66

Radiant Flame Sensor

This part senses the flame for heat allowing the gas valve to open.

$22.73

Internal-Bias Thermistor

Part may differ in appearance, but functions the same as original part. This part controls the temperature of the inside of the dryer drum and prevents the dryer from overheating.

$38.92

Dryer Repair Kit

This kit comes with one multi rib belt, four drum support rollers, one idler assembly, nine tri rings and one washer.

$13.56

Disposable Thermal Fuse - Two Terminal

This part attaches to the exhaust duct of your clothes dryer.

$3.84

Tri Ring

Sold individually.

$8.95

Light Bulb - 10W

This ten watt appliance light bulb is used with both washers and dryers. Sold individually.

$3.76

Moisture Sensor

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

felt strip came off lint screen

  • Customer: JEFFREY from FALL RIVER MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 88 of 114 people found this instruction helpful
ordered new lint screen, removed old screen, inserted new screen. read more

Dryer door catch broken

  • Customer: Tammy from Clute TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 60 of 62 people found this instruction helpful
After a few years of slamming the dryer door (at least that is what my husband says), the catch on the dryer door broke. Using pliers (I used needle nose) squeeze the outer edges of the catch together (vertically). With it compressed, it should slide out easily. My husband had jacked with ours prior to the repair, so the broken piece in the door was actua... read more

GAS FLAME WOULD DROP OUT

  • Customer: FRED from BRIELLE NJ
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 39 of 53 people found this instruction helpful
first it was a process of alimination to find out why it was dropping out. after the problem was found it was just a matter of replacing the holding coil on the gas valve.
THANK YOU
FRED KENNEY SR read more