These agitator directional cogs are commonly referred to as dog ears. They come four to a package and are usually used with direct drive washing machines.
This coupling kit is used between the motor and the transmission on direct drive washers with no belt. This is the newer version and is made with new metal sleeves for added strength.
It is intended for use with washing machines that do not have belts. This drain pump has two ports for water to pass through: a large one, and a smaller one.
Sold Individually. Appliance takes 3 of this part.
A worn clutch can cause a slower spin speed which will leave your clothes wet after a cycle.
This clutch assembly comes with brake cam driver, blue spring for large capacity wash...
This part could have either a blue colored valve body or a green colored valve body. There are two ports for water to enter and this valve is compatible with a half inch ID hose. It has two 3/4-11x1/2 NHT hose threads.
This kit included the cam, 4 dogs and bearing.
This kit contains one screw with rubber gasket and threaded sealant. The screw head is 7/16".
This part is used to balance the tub during spin cycle. Sold individually. It is recommended that you replace all 3 at the same time.
The pin on the lid pushes on the lever of the lid switch to tell the machine that the lid is closed. This part includes the grounding wire.
- Customer: Jeff from Wayne NJ
- Difficulty: Easy
- Time to Complete: 30 - 60 mins
- Tools Required: Pliers, Screw drivers, Socket set
- 583 of 619 people found this instruction helpful
The job looked intimidating but turned out to be very easy.
First take off the water pump by removing the two clips that hold it in place. Place a shallow pan under the pump to catch the water that is in the pump and hoses. Open the hose clamps with a pair of pliers or channel locks (better) and slide the hoses off of the water pump.
The motor co...
- Customer: mike from Kent WA
- Difficulty: Easy
- Time to Complete: 15 - 30 mins
- Tools Required: Screw drivers, Socket set
- 538 of 552 people found this instruction helpful
First pry off the cap of the agitator. Then using a socket remove the bolt that holds the plastic cup in place. Remove this cup by prying it loose from the two tabs that hold it in place. Once this cup is removed you can get to the broken cogs.
Slip the new cogs into the underside of the cup, and slide the cup back down in the agitator housing usin...
- Customer: Tom from Granby MA
- Difficulty: Really easy
- Time to Complete: Less than 15 mins
- Tools Required: Pliers
- 437 of 456 people found this instruction helpful
The hardest part of this job was pulling the machine away from the wall so the hoses could be disconnected and the machine flipped onto it's back. Putting the machine on it's back does two things. It drains the water left in the bottom of the tub so it won't pour out onto the motor when the old pump is removed, and gives the necessary access to the pump. ...