Models > 7EWTW1509YM0

7EWTW1509YM0 Whirlpool Washer - Overview

Get Parts and Repair Help for 7EWTW1509YM0

If you know the washer repair part you need, you can browse the list of all parts on the 7EWTW1509YM0, or you can search by name or part description. You can also find your part by where it is located on the 7EWTW1509YM0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for 7EWTW1509YM0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.61

Agitator Directional Cogs

These agitator directional cogs are commonly referred to as dog ears. They come four to a package and are usually used with direct drive washing machines.

$2.18

Inner Cap Seal

Also known as an O-Ring.

$43.77

Lid Latch Assembly

The point of the lid switch is for the tub to stop spinning when the washer lid is opened. It is a safety precaution just in case someone decides to stick their hand inside the wa...

$3.76

Agitator Cap Barrier with Seal

$2.70

Hose Clamp

$2.03

Lid Hinge Mounting Screw

Sold individually.

$2.70

Screw

This screw is sold individually.

$4.65

Touch-Up Paint - White

$3.96

D-Shaped Knob Insert

This insert is sold individually. Knob not included. Knob is sold separately.

$3.96

WASHER

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

washer wouldn't agitate

  • Customer: mike from Kent WA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 503 of 511 people found this instruction helpful
First pry off the cap of the agitator. Then using a socket remove the bolt that holds the plastic cup in place. Remove this cup by prying it loose from the two tabs that hold it in place. Once this cup is removed you can get to the broken cogs.
Slip the new cogs into the underside of the cup, and slide the cup back down in the agitator housing usin... read more

top half of agitator did not move during wash cycle

  • Customer: dennis from new stanton PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Socket set
  • 177 of 201 people found this instruction helpful
pull off softner dispenser, pop off agitator cap by inserting straight screw driver into small slot, remove bolt inside agitator with socket wrench and long extension, pull agitator straight up off shaft, place agitator on floor, with feet holding bottom half pull top half apart from bottom half by pulling straight up, note direction of old cogs remove and r... read more

Agitator was not working

  • Customer: Michael from Murray KY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Socket set
  • 38 of 46 people found this instruction helpful
Step 1) Take off top cap with a flat head screw driver.

2) unscrew bolt (may need extension as it may be deep in the agitator.)

3) Take upper agitator off.

4) remove clog retainer and clogs.

5) insert new clogs and re-assemble.

total time 10 to 15 min. read more