Models > 7EWTW1409YM0

7EWTW1409YM0 Whirlpool Washer - Overview

Get Parts and Repair Help for 7EWTW1409YM0

If you know the washer repair part you need, you can browse the list of all parts on the 7EWTW1409YM0, or you can search by name or part description. You can also find your part by where it is located on the 7EWTW1409YM0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for 7EWTW1409YM0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.46

Agitator Directional Cogs

These agitator directional cogs are commonly referred to as dog ears. They come four to a package and are usually used with direct drive washing machines.

$9.60

Agitator Cam Kit

This kit included the cam, 4 dogs and bearing.

$2.88

Inner Cap Seal

Also known as an O-Ring.

$3.96

Agitator Cap Barrier with Seal

$45.69

Latch Assembly

$3.96

Thrust Spacer

Sits in between the agitator base and upper agitator.

$2.70

Screw

This screw is sold individually.

$2.70

Hose Clamp

$70.46

Agitator

This agitator comes with the 4 agitator dogs (cogs) and top mover. The cap is NOT included with the agitator.

$3.96

WASHER

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

top half of agitator did not move during wash cycle

  • Customer: dennis from new stanton PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Socket set
  • 168 of 190 people found this instruction helpful
pull off softner dispenser, pop off agitator cap by inserting straight screw driver into small slot, remove bolt inside agitator with socket wrench and long extension, pull agitator straight up off shaft, place agitator on floor, with feet holding bottom half pull top half apart from bottom half by pulling straight up, note direction of old cogs remove and r... read more

Dog ears worn down; upper agitator not moving

  • Customer: shawn from la jolla CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 42 of 46 people found this instruction helpful
Pulled off the dispenser. Used socket set to remove bolt. Removed entire agitator out of washer. Placed both feet on bottom of agitator and then pulled up on the upper agitator. It took some muscle due to the years of washer use. I used a flat-head screwdriver to weaken the plastic clips holding down the old bearing-driven cam. Once I got the upper agi... read more

Agitator was not working

  • Customer: Michael from Murray KY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Socket set
  • 34 of 40 people found this instruction helpful
Step 1) Take off top cap with a flat head screw driver.

2) unscrew bolt (may need extension as it may be deep in the agitator.)

3) Take upper agitator off.

4) remove clog retainer and clogs.

5) insert new clogs and re-assemble.

total time 10 to 15 min. read more