Models > 79648852800

79648852800 Kenmore Washer - Overview

Get Parts and Repair Help for 79648852800

If you know the washer repair part you need, you can browse the list of all parts on the 79648852800, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$15.41

Water Inlet Valve - Hot

$1.96

Hinge

$1.96

Cap,Drain Hose

$15.41

Bearing,Ball

$8.18

Gasket

$81.34

Spider

$20.11

Bearing,Ball

$81.34

Drain Pump and Motor Assembly

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

$4.59

Clamp Assembly

$6.34

Pump Casing

This part connects to the drain pump and motor.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

split hose. water leaking on floor.

  • Customer: Scott from Parkland FL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers, Socket set
  • 0 of 0 people found this instruction helpful
Loosened hose clamps to remove old bellows. That seemed simple but was awkward reaching into the confined space. Clamp adjustments were all installed facing away from access opening. New one went on easy and I reinstalled clamps facing the opening. Perfect fit! read more

Washer flashes "FE" and water did not stop flowing during "Spin" cycle.

  • Customer: Jean-Mary from Havre de Grace MD
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers, Wrench set, Wrench(Adjustable)
  • 0 of 0 people found this instruction helpful
1. Remove Power from washing machine. Using an ajustable wrench,remove both the cold water and hot water hoses/lines from back of washing machine. 2. Unscrew the back plate, using the screwdriver (Phillips) and store back plate and screws for re-installation. 3. Using a small screwdriver (Phillips), remove the retaining plate fom the cold and hot water... read more

original spider broke

  • Customer: Robert from Buxton OR
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers, Socket set, Wrench set
  • 0 of 0 people found this instruction helpful
remove top and front of washer, disconnect hoses, weights, wires and motor cover from wash tub, remove tub assembly from washer by removing pins from dampers and lift off spring hangers, split washing tub to get to back of drum.unbolt old spider clean all the soap scum buildup and install new part, reassemble washer. works like new. read more