Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 740C

740C Maytag Dryer - Overview

Get Parts and Repair Help for 740C

If you know the dryer repair part you need, you can browse the list of all parts on the 740C, or you can search by name or part description. You can also find your part by where it is located on the 740C by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for 740C parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$5.17

Drum Roller Shaft Washer

This roller shaft washer is just under an inch in diameter and is used for some of Whirlpool's brands of clothes dryers.Sold individually.

$9.35

Rubber Foot Pad

This foot pad is just over an inch in diameter. It is made entirely of rubber and is gray in color. This pad is intended for use with washers and some dryers.

$5.10

Screw, 8/18 x 3/8

This screw is sold individually.

$10.35

Adjustable Levelling Leg

Sold Individually. This adjustable leveling leg comes with a stop nut.

$5.15

Cylinder Light Bulb

Sold individually.

$49.00

Water Inlet Valve

This water inlet valve is intended for use with under counter style dishwashers. It has a 3/8 of an inch FPT (female pipe thread) valve and a mounting bracket. - This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

$4.89

Screw

10 - 16 x .375

$2.78

Screw - 6-32 x 5/16

This screw is well under an inch long, and is made of metal.

$155.06

Oven Thermostat - 3 Wire

This eaton style three wire oven thermostat from Whirlpool/Kenmore has a temperature range between 140 degrees Fahrenheit and 550 degrees Fahrenheit. Its spring clip shaft is 3/4 o...

$30.36

Indicator Light Kit

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Leaky water inlet valve

  • Customer: Jack from Fort Worth, TX
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Wrench set
  • 17 of 20 people found this instruction helpful
Easy. Removed screws at top holding dishwasher to counter. Turned off water to dishwasher. Unhooked water supply line. Electrical and waste lines were long enough to leave connected and pull dishwasher out, set on side. Pull off electrical connector. Use pliars to compress spring holding water line to dishwasher, remove that line from valve. Use nut d... read more

Stripped leveler screw making impossible to level my washer

  • Customer: Rebecca from Wylie, TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Wrench set
  • 15 of 20 people found this instruction helpful
Put blocks under the washer where the leveling leg was needed and screwed the part into the washer. Then it was just a matter of moving the washer into place and leveling. Pretty easy. read more

burned out light bulb

  • Customer: Stephen from Glendale, AZ
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 3 of 6 people found this instruction helpful
removed the lens cover, replaced the bulb and reinstalled the lens cover. read more