Models > 72181622600

72181622600 Kenmore Microwave - Overview

Get Parts and Repair Help for 72181622600

If you know the microwave repair part you need, you can browse the list of all parts on the 72181622600, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.05

Light Bulb - 125V 30W

$3.05

Switch,Micro

$10.52

Filter,Grease

$21.46

Plate,Mount

$3.05

Bracket,Idle

$1.95

Damper

$1.95

Screw,Tapping

$3.05

Switch,Micro

$1.95

Connector Assembly

$3.05

Lamp Holder

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave failed to head and light, fan, and turntable failed to come on.

  • Customer: Robert from Cedar Park TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 0 of 0 people found this instruction helpful
Problem was due to a faulty door switch. Replaced with a new switch and the microwave now works fine! Only thing that was tricky was that LG uses the hex screws with a peg in the middle to keep the microwave cover on. Had to use a small screwdriver and pliers (on the screwdriver) to unscrew the screws. read more

suddenly stopped working while in use

  • Customer: Kevin from Colonia NJ
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
i unplugged the unit,unscrewed the outer shell so that all the wiring and internal components were visible.starting at the first of three micro switches i removed the slip on terminals installed the alligator clips too the wires so the switch would now be bypassed.i made sure the wires and clips were not touching anything plugged unit in and it worked.i then... read more

turn table motor

  • Customer: Gary from Desert Hot Springs CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
remove the screws from the bottom, leave tthe light wires attached. There are two screws holding the motor on, disconnect and mark the old unit where the yellow wire goes. Mount motor with two screws and connect wires. Turn on Miicrowave for 10 sec, to be sure all is correct. Attacch bottom cover and reattach power cord. Before doing anything make sure power... read more