Models > 72162772200

72162772200 Kenmore Microwave - Overview

Get Parts and Repair Help for 72162772200

If you know the microwave repair part you need, you can browse the list of all parts on the 72162772200, or you can search by name or part description. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.06

Light Bulb - 125V 30W

$10.52

Filter,Grease

$3.06

Switch,Micro

$3.06

Switch,Micro

$1.96

Connector Assembly

$6.34

Cable,Assembly

$20.11

Capacitor,High Voltage

$1.96

Fuse,Time Delay

$1.96

Spring

$4.59

Tape,Sealing

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave failed to head and light, fan, and turntable failed to come on.

  • Customer: Robert from Cedar Park TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 0 of 0 people found this instruction helpful
Problem was due to a faulty door switch. Replaced with a new switch and the microwave now works fine! Only thing that was tricky was that LG uses the hex screws with a peg in the middle to keep the microwave cover on. Had to use a small screwdriver and pliers (on the screwdriver) to unscrew the screws. read more

Microwave operated but did not heat

  • Customer: Donald from Oak Ridge TN
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Initial failure of over range microwave Aug 3rd. Control Panel worked but no heat. Took to local LG authoriaed local repair place. They fixed it quickly and we re-installed it. Worked fine for 2 months then had similar failure again. Agaim took to same authorized repairer. They kept unit for 3 months but finally concluded theu could not fix it and suggeste... read more

suddenly stopped working while in use

  • Customer: Kevin from Colonia NJ
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
i unplugged the unit,unscrewed the outer shell so that all the wiring and internal components were visible.starting at the first of three micro switches i removed the slip on terminals installed the alligator clips too the wires so the switch would now be bypassed.i made sure the wires and clips were not touching anything plugged unit in and it worked.i then... read more