Models > 6WSC20C6YY00

6WSC20C6YY00 Whirlpool Refrigerator - Overview

Sections of the 6WSC20C6YY00

[Viewing 12 of 12]

Manuals & Care Guides for 6WSC20C6YY00

Click to download
Keep searches simple, eg. "belt" or "pump".
Refrigerator Ice and Water Filter – Part Number: EDR1RXD1
Refrigerator Ice and Water Filter
★★★★★
★★★★★
(101)
PartSelect #: PS11701542
Manufacturer #: EDR1RXD1
This is an OEM replacement ice and water filter for your refrigerator. In side-by-side refrigerators, it is found in the top right corner or the bottom left grille. In bottom-freezer refrigerators, th...
$103.96
  In Stock
Refrigerator Air Filter – Part Number: W10311524
Refrigerator Air Filter
★★★★★
★★★★★
(43)
PartSelect #: PS2580853
Manufacturer #: W10311524
This Refrigerator Air Filter is a white 1.8x3.2" plastic filter which neutralizes odor and bacteria in the air. It should be replaced every six months at a minimum. Refer to your user manual and model...
$21.56
  In Stock
Refrigerator Door Switch – Part Number: W11384469
Refrigerator Door Switch
★★★★★
★★★★★
(83)
PartSelect #: PS12728638
Manufacturer #: W11384469
Door switch turns the light off when you close the door.
$38.48
  In Stock
Touch-Up Paint - White – Part Number: 72017
Touch-Up Paint - White
★★★★★
★★★★★
(1)
PartSelect #: PS385132
Manufacturer #: 72017
This touch-up paint can be used on a wide variety of household appliances. It is most often used on washers, dryer, refrigerators, dishwashers, ranges, freezers, trash compactors, or microwaves. It is...
$8.00
  In Stock
Screw – Part Number: WP489483
Screw
★★★★★
★★★★★
(1)
PartSelect #: PS11742755
Manufacturer #: WP489483
This screw is sold individually.
$13.09
  In Stock
Seal – Part Number: WP2198628
Seal
★★★★★
★★★★★
(4)
PartSelect #: PS11739241
Manufacturer #: WP2198628
This part is a replacement refrigerator drive shaft seal for your refrigerator. The drive shaft seal protects the auger motor from water and condensation that may leak down the drive shaft from the ic...
$14.58
  In Stock
Evaporator Fan Blade – Part Number: WP2169142
Evaporator Fan Blade
★★★★★
★★★★★
(4)
PartSelect #: PS11738973
Manufacturer #: WP2169142
If your refrigerator or freezer is too warm, or making noises, you may need to replace the fan blade. The fan blade attaches to the evaporator motor, which is in the freezer section, to help circulate...
$37.20
  In Stock
Thimble Top – Part Number: WP2182181
Thimble Top
★★★★★
★★★★★
(2)
PartSelect #: PS11739043
Manufacturer #: WP2182181
For white, biscuit, black and stainless models.
$11.14
  In Stock
Screw – Part Number: WP489478
Screw
★★★★★
★★★★★
(1)
PartSelect #: PS11742754
Manufacturer #: WP489478
Sold individually.
$5.42
  Special Order
Fan Blade – Part Number: W10156818
Fan Blade
★★★★★
★★★★★
(15)
PartSelect #: PS1964356
Manufacturer #: W10156818
The fan blade is used to blow air over the condenser.
$65.94
  In Stock
Coupling – Part Number: WP2220458
Coupling
★★★★★
★★★★★
(3)
PartSelect #: PS11739763
Manufacturer #: WP2220458
This coupling is used for indoor ice dispensers.
$28.52
  In Stock
SET SCREW - DOOR HANDLE – Part Number: W11366418
SET SCREW - DOOR HANDLE
★★★★★
★★★★★
(5)
PartSelect #: PS12723933
Manufacturer #: W11366418
This screw is for refrigerators. Follow appropriate safety practices when installing screw
$13.10
  In Stock

Questions And Answers for 6WSC20C6YY00

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

3 questions answered by our experts.
Sort by:
  • 1
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Melinda
July 2, 2021
What seems to be the problem when freezer stops working, but blower inside freezer working but not frosting
For model number 6WSC20C6YY00
PartSelect logo
Hello Melinda, Thank you for the question. We suggest testing the Thermistor, PartSelect Number PS2580944. The best way to do this is to remove the thermostat from the refrigerator so you can control the temperature of the sensor. You can let the sensor warm up to room temperature. With the sensor warmed up to room temperature the sensor should read approximately 6.2K Ohms at 68°F. With the thermistor submerged is a glass full of ice water, the sensor should be very close to 32°F which should read approximately 16.3K Ohms. If the values that you are getting are far off from these readings, then the sensor is bad and should be replaced. Thank you for your inquiry, good luck with this repair!

1 person found this helpful.

Was this helpful?
Thank you for voting!
Related Parts:
Melinda
July 2, 2021
Still related to freezer problem, I checked that the fan installed at the lower back alongside compressor is not working properly. It functions only from the time you plugged in the refrigerator but once it stops it doesn't go back as it usually does and the freezer will melt. Does it had to do with the control main board installed side to the compressor? I'm clueless because were trying to look into manual of model part but doesn't exist. Please help.
For model number 6WSC20C6YY00
PartSelect logo
Hello Melinda, Thank you for the question. This normally indicates the Fan Motor will need to be replaced. We hope this helps!

1 person found this helpful.

Was this helpful?
Thank you for voting!
Related Parts:
Mark
December 31, 2023
Hi I looking for a Pc main board the part no on the old board is W10235413
For model number 6WSC20C6YY00
PartSelect logo
Hello Mark, thank you for the great question. The part you are looking for is part number PS11750760. Please reach out to customer service if you need help placing an order, anyone will be happy to assist you!

Was this helpful?
Thank you for voting!
Related Parts:
  • 1

Common Symptoms of the 6WSC20C6YY00

[Viewing 12 of 12]
Light not working
Fixed by
these parts
Fixing Fixing Fixing
Show All
Noisy
Fixed by
these parts
Fixing Fixing Fixing
Show All
Leaking
Fixed by
these parts
Fixing Fixing Fixing
Show All
Door won’t open or close
Fixed by
these parts
Fixing Fixing Fixing
Show All
Ice maker won’t dispense ice
Fixed by
these parts
Fixing Fixing Fixing
Show All
Fridge too warm
Fixed by
these parts
Fixing Fixing Fixing
Show All
Ice maker not making ice
Fixed by
these parts
Fixing Fixing Fixing
Show All
Not dispensing water
Fixed by
these parts
Fixing Fixing
Show All
Fridge too cold
Fixed by
these parts
Fixing Fixing
Show All
Clicking sound
Fixed by
these parts
Fixing Fixing
Show All
Ice maker dispenses too little ice
Fixed by
these parts
Fixing
Show All
Door Sweating
Fixed by
these parts
Fixing
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Lights inside refrigerator not working
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again.
Parts Used:
Refrigerator Door Switch
  • Clint from Rayville, MO
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
120 of 196 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Light Switch broke
An easy job for smaller hands. Removed the two bolts holding the light cover. Removed two electrical connections from the old switch by pinching the retaining clip,removed the switch, snapped in the new one and re-attached the connectors. Your online illustrations helped me to know that the plastic housing for the light switch would only swing down so far and was not intended to be removed. Saved me from breaking that plastic cover's tabs. This home repair saved me more than 5 times the cost of hiring a professional to do it. Very happy homeowner.
Parts Used:
Refrigerator Door Switch
  • James Richard from St. Cloud, MN
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Socket set
44 of 60 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Scratches in Surface
This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great.
Parts Used:
Touch-Up Paint - White
  • Michelle from Richardson, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
65 of 126 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!