Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 668WJ-ASAW

668WJ-ASAW Admiral Range - Overview

Get Parts and Repair Help for 668WJ-ASAW

If you know the range repair part you need, you can browse the list of all parts on the 668WJ-ASAW, or you can search by name or part description. You can also find your part by where it is located on the 668WJ-ASAW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for 668WJ-ASAW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

$28.90

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$19.77

Terminal Block

It provides a way of connecting individual electrical wires and offers protection of the device from electrical surges (voltages and/or currents).

$69.97

Surface Element Kit with Limiter - 6"

This ceramic element kit comes with an overheat limit switch, two wires, and two wire connectors.

$6.90

CLEANER

$6.28

Screw (4)

Sold Individually.

$9.58

Oven Door Spring

This oven door spring is six inches long, and is made of metal.

$2.76

Frame Screw

Sold Individually.

$51.47

Bake Element (15" long x 19" wide)

This spade style bake element with push on wire terminals is 15 inches long and 19 inches wide. The depth of the terminals is three inches.

$5.15

Screw

This screw is sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford, MA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 112 of 130 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more

F1-1 code

  • Customer: charles from marstons mills, MA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 48 of 62 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the sensor out about 3 inches and disconnected the two wires. Next, I connected new sensor and screwed the new sensor back in place. One area for caution. Make sure that the electrical connection is pushed in past the insulation on the back side of the oven. Failure to do so will ... read more

Burned terminal block and filter board

  • Customer: Joseph from Decatur, GA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set, Wrench set
  • 67 of 146 people found this instruction helpful
Removed and replaced above named parts, rewired.Be sure to tighten all nuts that secure wires. I believe this is what caused the problem. read more