Models > 667WJ-TSAW

667WJ-TSAW Admiral Range - Overview

Get Parts and Repair Help for 667WJ-TSAW

If you know the range repair part you need, you can browse the list of all parts on the 667WJ-TSAW, or you can search by name or part description. You can also find your part by where it is located on the 667WJ-TSAW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for 667WJ-TSAW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the 667WJ-TSAW [Viewing 3 of 3]

$2.52

Light Bulb - 40W

Sold individually.

$28.12

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$18.07

2 Piece Broiler Pan

$17.20

Terminal Block

It provides a way of connecting individual electrical wires and offers protection of the device from electrical surges (voltages and/or currents).

$5.10

Oven Door Spring

Sold individually.

$34.32

Bake Element

This spade style bake element has push on wire terminals. It is found on the bottom of the oven.

$6.20

Screw - sold individually

$60.64

Surface Element Kit with Limiter - 6"

This ceramic element kit comes with an overheat limit switch, two wires, and two wire connectors.

$2.70

Hex Nut

Part may differ in appearance, but functions same as original.

$113.75

Burner Element with Limit Switch - 8"

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford MA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 73 of 82 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more

F1-1 code

  • Customer: charles from marstons mills MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 28 of 32 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the sensor out about 3 inches and disconnected the two wires. Next, I connected new sensor and screwed the new sensor back in place. One area for caution. Make sure that the electrical connection is pushed in past the insulation on the back side of the oven. Failure to do so will ... read more

replaced heating element on flat surface stove top

  • Customer: dennis from assonet MA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 20 of 28 people found this instruction helpful
I removed 4 screws and then lifted up the top it gave me access to the element I followed the direction that came with the element (very clear to follow) removed and installed the new element and it worked fine. Remember to unplug the stove if it is electric this is not in the instructions. read more