Models > 66568611891 > Instructions

66568611891 Kenmore Microwave - Instructions

All installation instructions for 66568611891 parts

These instructions have been submitted by other PartSelect customers and can help guide you through the microwave repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the 66568611891
31-45 of 84
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

loose handle

  • Customer: David from Littleton CO
  • Difficulty: Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required:
  • 5 of 10 people found this instruction helpful
This is not easy to do. I done it before to replace a broken window and it was a real bitch. I considered buying a new door rather then do it again.All I wanted to do was tighten two screws that hold the handle.
I used the advice found on your web site from a person who did it using quarters and putty knifes to remove the choke and the door insert. Sounded silly but it works like a charm. I advise anyone who needs to do this repair to use that info on your web site. It will save lots of frustration. Be sure to have plenty of quarters and a few pennies.

Microwave Turntable Won't Rotate

  • Customer: Steven from Sacramento CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 5 of 10 people found this instruction helpful
I turned off the power to the oven at the breaker. I then removed the side trim pieces by removing the screws located behind the lower oven door. I removed the plastic trim pieces above and below the microwave oven and removed the control panel and slid it into the opening above the microwave. I located the two screws securing the microwave into the frame and began sliding it out. I had to disconnect a small wiring harness and two wires from the microwave that were attached inside the opening above the microwave. The microwave section was the easily slid out, turned on it's side where the turntable motor was accessed by removing the access panel. I pulled the old motor, checked resistance and it matched the new motor. I then checked the old motor by applying 120V to it and it ran FINE! I thought I had the wrong part, but decided to install the new motor anyway. I did, secured the access panel and replaced the microwave in the frame. I reconnected the wires and secured the control panel and tested the microwave...and the turntable works!

bought microwave at Garage sale, but with no mount bracket

  • Customer: Jesus from Lincoln NE
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 8 of 20 people found this instruction helpful
I was able to buy the mounting bracket for a very cheap price and was able to instill it in my kitchen with ease.
Thank you

smoke alarm went off while frying

  • Customer: Alma from Florence SC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 2 of 3 people found this instruction helpful
both of the pieces have a tab that help remove the pieces. They slip right out and new ones are putin place.

Broke rotating plate, it fell off counter after being washed

  • Customer: Lois P from Morris IL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 2 of 4 people found this instruction helpful
Opened door and put new plate in.

Placed order on Thursday evening and received Sat Am

microwave door frame cracked in two spots

  • Customer: Wayne from Arlington WA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 2 of 4 people found this instruction helpful
ordered supplies on line (awesome!) Took apart old door added new frame. It was a snap!

BURNT OUT LIGHT BULB REPLACEMENT

  • Customer: alfred from summerville SC
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 6 of 16 people found this instruction helpful
OPEN COMPARTMENT, INSTALLED BULB, CLOSED COMPARTMENT

Dropped the glass cooking tray and it broke in half

  • Customer: Emily C from Brandon MS
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 1 of 2 people found this instruction helpful
Looked up the Whirlpool Co. and ordered the part. It was quite simple. Arrived in 2 days and I simply placed it in the microware. It was very very easy!

E. Robinson

glass turntable broke in half, ring turn needed replaced

  • Customer: Gail from Cincinnati OH
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 1 of 2 people found this instruction helpful
I removed the broken tray and ring-turn and replaced it with the new
Service was fantastic, parts were ordered one day and received the next

cooking tray chipped

  • Customer: Nancy from Henderson NV
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 1 of 2 people found this instruction helpful
replaced with new one

broken glass tray

  • Customer: Mary from Ocala FL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 1 of 2 people found this instruction helpful
Washed the glass tray and put in the microwave oven. Easy..

"Lost" microwave tray

  • Customer: Amelia from Charleston SC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 1 of 2 people found this instruction helpful
Took out the turntable parts to ensure I ordered the correct cooking tray. Matching those with photos of related parts on PartSelect worked great. Put turntable drive and support ring in place and cooking tray went in very easily. Plan to order a second one to have on hand for this rental property.

Replace cracked vent grille

  • Customer: William from San Diego CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 1 of 3 people found this instruction helpful
Backed out the screws, removed cracked grille. Installed new perfectly matched grille, screw down. Done.

Turntable coupling

  • Customer: Laura from Port St Lucie FL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 1 of 3 people found this instruction helpful
Rep knew exactly what I needed when I described where the part should go on my microwave - price great - shipping great - installed in seconds. Thank you!

The old coupling melted and the tray cracked in half.

  • Customer: Diane from Sheridan AR
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 1 of 3 people found this instruction helpful
It took me 15 minutes total - 5 minutes to clean the microwave, 1 minute to install three new parts, and 9 minutes to enjoy my celebratory glass of wine!
All Instructions for the 66568611891
31-45 of 84