66561682102 Kenmore Microwave - Instructions

I removed the broken tray and ring-turn and replaced it with the new
Service was fantastic, parts were ordered one day and received the next

Washed the glass tray and put in the microwave oven. Easy..

Removed turntable
Place support ring in track
Place turntable on support ring.
Easy, peasy!

I ordered the handle and one screw (I thought they were 2 per pack). I removed the handle and replace it using the new screw and one of the old screws. It was VERY easy.

Rep knew exactly what I needed when I described where the part should go on my microwave - price great - shipping great - installed in seconds. Thank you!

I ordered another one and placed it inside the microwave. It works and fits perfectly. I received the order exactly as scheduled.

Looked up the Whirlpool Co. and ordered the part. It was quite simple. Arrived in 2 days and I simply placed it in the microware. It was very very easy!

E. Robinson

Hello,
I unscrewed the two screws on the edge of the door. Then gently wiggled the door frame (front cover) loose (this was the first time its been off so there was grease build up in places that I never saw) once off just unscrewed screw and put back on microwave cover screwed outer screws in and good as new!

easy to replace, just the same as cleaning the turntable and placing back in the micorwave;

Took out turntable and swapped out old one with a new bright and shiny
New one, ring that is. It was easy using the part from parts select
Thanks
Paul

Ordered a new motor. Removed the outside trim of the oven-microwave combo. 2 screws at the bottom of the trim. Removed the screws that held the combination micro and oven unit in place. Removed the top and bottom black plastic grill of the microwave. 3 screws each. Pulled the entire unit out about 1 inch exposing the screws at each side of the microwave that hold it in place.
Snapped off the top control panel which exposed the wiring connecting the control panel.
Unplugged a couple of wire harness units to free the control panel.
Be sure to label the units to know which goes where during reassembly.
Remove the microwave unit from the housing and place it on its side.
Remove the metal plate that houses the motor. 4 screws hold the motor in place. Disconnect the 2 wires from the old motor and you are ready to install the new motor. Be sure to TURN OFF THE POWER to the unit at the breaker box and remove the turntable from inside the microwave.

First, we had to clean up all the interior surfaces, which was just cleaning. There was no internal damage. Then, just setting the center connector, rotary rollers and glass plate. Simple

The top of the handle was fine and the screws that held it in place are totally accested from inside the door(2 screws).The bottom 2 screws are 'hidden' by the inside of the door. You don't have to remove the door itself(unless you want to), but you do have to remove the inner door panels (there is a black band between the 2 white door pieces) to access the 2 remiaining screws. I found that a putty knife was a good tool to use. Work from the hinge part of the door to the handle end. The top was easier than the bottom? Once the back is loose enight to access the bottom screws you are basically done. Screw in the new handle with the old screws(hope you didn't thro them away). Reassemble the back(inside) of the door. Just put the black band on the glass portion and push back together.

Opened door and put new plate in.

Placed order on Thursday evening and received Sat Am

It took me 15 minutes total - 5 minutes to clean the microwave, 1 minute to install three new parts, and 9 minutes to enjoy my celebratory glass of wine!