66121 ((1988)) Kenmore Range - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
oven not up to temperature; shuts off before temp set
Took amp reading, which was 2.5 amps, that identified that the igniter needed to be replaced, for the safety valve requires 3.2 amps or better. Replaced, and everything is okay.
Parts Used:
-
Maurice from Overland Park, KS
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Pliers, Screw drivers
8 of 9 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Igniter
No problem getting to igniter in oven to remove from holder. Difficult to disconnect igniter at rear after removing drawer. Just hard to get to. Broke one of the plug-in receivers so had to crimp on a new one. This was a hinged pair that received the igniter lead and another lead that went to another part.
Parts Used:
-
GENE from HEBRON, OH
-
Difficulty Level:Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers, Socket set
5 of 6 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Oven Igniter DEAD
First wrote a wiring diagram then disconnected old igniter by removing two screws and unplugging.
Then just reversed the whole operation.
However, it never worked because the "oven/broiler" switch broke.
Its time for a new stove.
But I would recommend PartsSelect to anybody.
Your selection is great, you shipped as promised, and the best part was the price.
Then just reversed the whole operation.
However, it never worked because the "oven/broiler" switch broke.
Its time for a new stove.
But I would recommend PartsSelect to anybody.
Your selection is great, you shipped as promised, and the best part was the price.
Parts Used:
-
Steve from Flanders, NJ
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
4 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Oven would not light
Removed old ignighter and replaced it with the new one. No brainier. Took longer to find the correct part, mine had three wires, most are just two.
Parts Used:
-
christine from new york, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!