Models > 65C

65C Maytag Dryer - Overview

Get Parts and Repair Help for 65C

If you know the dryer repair part you need, you can browse the list of all parts on the 65C, or you can search by name or part description. You can also find your part by where it is located on the 65C by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for 65C parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Drum Roller Shaft Washer

This part is sold individually.

$3.76

Adjustable Levelling Leg

Sold Individually. This adjustable leveling leg comes with a stop nut.

$8.46

Rubber Foot Pad

This foot pad is made entirely of rubber and is gray in color. This pad is intended for use with washers and some dryers. Sold individually.

$2.70

Hex Nut

10-32 hex - Sold Individually - Appliance originally takes 3 of this item.

$2.70

Screw - 6-32 x 5/16

$3.83

NUT- LOCK

$42.63

Terminal Block with Nuts and Washers

$4.46

SCREW

10 - 16 x .375

$2.70

Nut

SCREW

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Stripped leveler screw making impossible to level my washer

  • Customer: Rebecca from Wylie TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Wrench set
  • 7 of 10 people found this instruction helpful
Put blocks under the washer where the leveling leg was needed and screwed the part into the washer. Then it was just a matter of moving the washer into place and leveling. Pretty easy. read more

worn roller wheel and bearing

  • Customer: David from Chadds Ford PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set, Wrench set
  • 0 of 1 people found this instruction helpful
replaced worn parts read more

Leg was mssing after move into new home.

  • Customer: Matthew from The Woodlands TX
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Wrench(Adjustable)
  • 0 of 0 people found this instruction helpful
Purchased x4 new adjustable legs. Leaned the washer back and held in place with block of wood. Loosened the two older front legs with an adjustable wrench because they had a locking nut and replaced with new legs. Repeated process on back side of washer. Once all the new legs were installed leveled the machine adjusting the legs if necessary. read more