Models > 653AJ-V Maytag

653AJ-V Admiral Range - Overview

Get Parts and Repair Help for 653AJ-V

If you know the range repair part you need, you can browse the list of all parts on the 653AJ-V, or you can search by name or part description. You can also find your part by where it is located on the 653AJ-V by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the 653AJ-V [Viewing 2 of 2]

$30.05

Burner Control Switch - 250V

This switch controls both the 6" and 8" surface burners. Shaft is 1" long and had a D-shape.

$39.45

Door Handle - White

Mounting hardware is sold separately.

$3.82

Main Top Hinge Spacer

$25.65

SEAL-STRIP

$22.57

LIGHT-IND

Drawer Glide

It is used with a range's runner to help the drawer glide in and out easily.

$3.71

Door Glass Clip

This clip is sold individually. It is used to fasten the door glass.

$3.71

NUT- PUSH-

$3.71

SPACER, GLASS CORNER

SWITCH, SELECTOR

Common Symptoms of the 653AJ-V [Viewing 1 of 27]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

burner would not work

  • Customer: David from Bellefonte PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 2 of 2 people found this instruction helpful
slide stove out unplugged it took six screws out put new one in transfered wires pluged back in and it works thank you read more

A switch on a front burner went out

  • Customer: thomas from South Bend WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 2 of 6 people found this instruction helpful
I first removed the back panel that covers the switches from back of stove; then I removed the wires and put them on the same numbered wires on the new switch; put the new switch in place with the wires connected to it; installed the 2 front screws and put the back cover on again & it took about 10 min and saved about $300. read more

Burner did not heat, but element is ok.

  • Customer: Philip from Hull MA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
The Burner Control Switch - 250V Part Number: PS2089409 that this site recommended was the right part for this older range. Had to remove screws to pull out the front panel with knobs, but it only pulls out a couple inches due to wires so it is tight to remove old switch. The five tabs are not in same spot so go by the labels and the wire lugs fit just fin... read more