Models
>
5871469080
5871469080 Kenmore Dishwasher - Overview
Sections of the 5871469080
[Viewing 7 of 7]Keep searches simple, eg. "belt" or "pump".
Heating Element Brass Nut
PartSelect #: PS1524878
Manufacturer #: 154106202
The heating element nut is used to connect the heating element to the dishwasher tub. If water is leaking from underneath your dishwasher, you may need to tighten or replace the heating element nut. R...
$7.81
In Stock
Single Door Spring
PartSelect #: PS452475
Manufacturer #: 5300809703
NOTE: Sold individually. This door spring is four and a half inches long. It is used for some dishwashers. These springs tend to wear out at the same rate, so you should replace both of your dishwashe...
$30.29
In Stock
Door Gasket
PartSelect #: PS452429
Manufacturer #: 5300809611
This tub gasket, also known as a door seal, is used for dishwashers. This one-piece part provides a water-tight seal between the dishwasher tub and door to prevent water leakage. If you find your dish...
No Longer Available
Access Panel Screw - Black
PartSelect #: PS649154
Manufacturer #: 154419403
Sold individually.
$10.73
In Stock
Water Inlet Valve
PartSelect #: PS452425
Manufacturer #: 5300809606
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.
No Longer Available
Rinse Aid Cap
PartSelect #: PS451734
Manufacturer #: 5300807673
This white rinse aid cap is a little over two inches long. It comes with a black rubber gasket, and is used for some dishwashers.
No Longer Available
Detergent Cup Kit
PartSelect #: PS470413
Manufacturer #: 5303943073
This detergent cup repair kit comes with the cam, spring and o-ring.
$61.48
Special Order
Lower Rack Roller Assembly
PartSelect #: PS452142
Manufacturer #: 5300808968
This lower rack roller assembly supports and guides the lower rack as it slides in and out of your dishwasher. This assembly consists of two wheels that are mounted on a bracket and is usually found o...
No Longer Available
Pump Motor Shaft Seal
PartSelect #: PS451182
Manufacturer #: 5300803903
This pump motor shaft seal will help prevent the water inside the dishwasher from leaking around the shaft of the motor.
$121.93
Special Order
Dishwasher Diffuser
PartSelect #: PS420080
Manufacturer #: 154183401
This part spins the water and/or water with detergent to propel it up and throughout the lower spray arm.
No Longer Available
Rinse Agent Grommet
PartSelect #: PS451262
Manufacturer #: 5300805631
With the rinse agent grommet it prevents leakage between the doors for the dispenser.
No Longer Available
Questions And Answers for 5871469080
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the 5871469080
[Viewing 3 of 3]Leaking
Fixed by
these parts
these parts
Show All
Door latch failure
Fixed by
these parts
these parts
Show All
Will not fill with water
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Water leaking under the dishwasher
I looked under and found that 2 brass nuts that secured the heater element through the base housing of the dishwasher has split down each side of the nut and no longer was tight enough to keep water from leaking around either end of the heater element. I powered down the dishwasher at the circuit breaker and then reached under the dishwa
... Read more
sher and pulled away the 2 wires that were attached to each side of the heater element. I removed the two nuts and replaced them with the parts I ordered from partselect.com. I then put the appropriate wires back at the end of the heater element and ran the dishwasher to check for leaks. No leaks... it was fixed.
Read less
Parts Used:
-
Dennis from Tryon, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Wrench (Adjustable)
77 of 82 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dishwasher leaked
First I noticed that the old gasket had disintergrated along the bottom. Next I removed the the gasket being careful to observe how it was installed. There are these notched areas of the gasket that belong in the lower corners. I think the notches are designed to help hold the gasket in place and make the gasket bend around the corner.
... Read more
The gasket made closing the door very hard at first but after one wash cycle the fit became much more comfortable. The heat probably made the gasket more pliable. Problem solved.
Read less
Parts Used:
-
Darren from Biddeford, ME
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
39 of 44 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Bad door gasket-leaking, broken door spring
My door spring had broken and I was going to leave it until the door gasket failed and started leaking. After removing the parts, I got on-line and order what I needed. I found everything easier than I thought. I got the parts a few days later and put the gasket in first. Looking at it, you'll find theres slotted ribs at both ends. Those
... Read more
areas go in the bottom corners because of the "S" curve. Simply push in and voila, you're done. At first the door will be firm to shut, but gets better- NO LEAKS! As far as the door spring...you don't have to remove the whole dishwasher. Simply unscrew the bottom plate under the door and reach in, rehook. Piece of cake. This site is wonderful. All the parts and easy to use.
Read less
Parts Used:
-
Randy from Orlando, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
17 of 18 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!