57731H7WW General Electric Washer - Instructions

I took the old hose off and replaced it with a new one!!
It was an easy fix

Just traded out the hoses and installed washer and started washing. Also got the replacement hose in a very timely manner, in turn only without washer for 5 days total. Thank You

Replace with new hose.

I took a pair of pliers removed the clip and pushed the new one on. Easy fix .

I looked up what others said about the same problem. Took their advice, ordered the pump and it was installed in less than 30 minutes. This is the third time that we have ordered parts and have had excellent service. We usually get the parts the next day or at most two days. Instructions to repair are exactly like the customers say on the website. I tell all my friends and relatives about your site.Thanks PartSelect!

Trouble shooting on internet only mentioned worn drive belt as a cause for no spin. No mention of the possibility of a transmission problem burning out the centrifugal clutch. So the drive belt was ordered and when I checked tracking when it was late, I was informed that it was already delivered and signed for by some stranger, jmorris. Later that night I found the package at my door to late to do the repair that night. The next evening the repair was attempted and it was not difficult with the youtube video for guidance. Back together but it did not spin or agitate. On the third run dthrough the procedure I noticed that the clutch was really hot and the notor was not locked. But the big pully would not complete but bart of a revolution and hard stop. The repair was a failure and after the time spent diagnosing the wrong problem with inadiquate trouble shooting on the internet chart and the time ordering and waiting for the second chance delivery. The failed repair delayed to the point that the customer did not have time to do their laundry berore their weekend trip. They will have to get a new machine after waisting so mych time with a less than fully informed repair attempt. The internet trouble shooting help was inadequate. The delivery of the parts was botched using FedEx instead of UPS. At the last minute after hours of involvement it came to light that the machine was history and we were suckered into buying the wrong part and running out of time for the customer to ready their clothes for their trip. I felt so bad of the machine resisting the repair process thaqt I discounted my labor time and told the customer pay me what they felt would be ritght. It was not all part selectt's fault but they had their page in the story.

The part came after 2 days..terrrific.. upon receipt, i attached the new one to the back of the washer and screwed. it all took about 5mins. My washer is back in business. I am very happy abouit it.
thank u.

I just pushed the new knob on the shaft and was done

took off the front and replaced easily. I tested it and it worked! The trick to remove front panel is use 2 screwdrivers, one on side, one in front even to lid edge.

The repair was an easy fix. Since the washing machine was already away from the wall, all we had to do was push(in a screwing motion) the hose in the back of the washer. It sealed right up and we were doing laundry 15min later.

Removed plastic pin holding knob with long nose pliers. Pulled off knob & replaced with new unit.

The delivery service was the fastest I have ever experienced.
Thank You

It was very easy to fix the problem with the new control knob. Watched a short video explaining how to remove old one and it worked.

remove screws from bottom of washer to remove the bottom of the washer so you can access the pump and motor assy. and remove two hose clamps.

watched video a couple of times and then did exactly as shown. surprise , i did it myself!

just like the video showed/////only idid not kno the water would escape from one of the hoses when removed///video did not prepare me for this