Models > 56-9381-10-04

56-9381-10-04 Tappan Microwave - Overview

Get Parts and Repair Help for 56-9381-10-04

If you know the microwave repair part you need, you can browse the list of all parts on the 56-9381-10-04, or you can search by name or part description. You can also find your part by where it is located on the 56-9381-10-04 by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$4.16

Touch Up Paint

This 18 ml bottle of white appliance touch up paint is a little over two inches tall. It can be used for refrigerators, microwaves, ranges, clothes dryers, and freezers.

$28.68

Carousel Tray Drive Bushing

$5.71

SCREW

$0.73

NUT

Interlock Switch

This part is used to stop the flow of electrical current when the door is opened to prevent any microwave energy escaping.

MOTOR-TURNTABLE

FUSE

SPACER

$2.38

RIVET COVER (8)

$3.00

BEZEL-LATCH

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

TURN TABLE WAS UNABLE TO TURN TO HEAT FOOD PROPERLY AND THOROUGHLY

  • Customer: Wendy from Shermansdale PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 2 of 3 people found this instruction helpful
I PULLED OUT THE GLASS TURN TABLE TRAY AND PUT THE BUSHING IN THE LITTLE WHOLE, IN THE CENTER OF THE BOTTOM (UNDER TURN TABLE TRAY). FIXED THE PROBLEM RIGHT AWAY. WORKING WONDERFUL! WAS HAPPY WITH HOW EASY IT WAS TO LOCATE PART. HAD RECEIVED THIS MICROWAVE AS A WEDDING GIFT, FEB.1994. THOUGHT I WAS GOING TO HAVE TO REPLACE. THANKS TO YOUR WEBSITE I WAS ABLE ... read more

Turntable motor was worn out - gears were slipping

  • Customer: Chad from Roanoke VA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 1 of 2 people found this instruction helpful
The job was very simple, remove the bottom plate of the microwave which is four screws and it exposes the motor. There are two screws which hold the motor in place that you access from inside the unit. Remove the two screws being carefull not to lose the gasket that is in between the motor and the bottom of the unit. Set the new motor in place being sure to ... read more