TURN TABLE WAS UNABLE TO TURN TO HEAT FOOD PROPERLY AND THOROUGHLY
- Customer: Wendy from Shermansdale PA
- Difficulty: Really easy
- Time to Complete: Less than 15 mins
- Tools Required:
- 2 of 4 people found this instruction helpful
I PULLED OUT THE GLASS TURN TABLE TRAY AND PUT THE BUSHING IN THE LITTLE WHOLE, IN THE CENTER OF THE BOTTOM (UNDER TURN TABLE TRAY). FIXED THE PROBLEM RIGHT AWAY. WORKING WONDERFUL! WAS HAPPY WITH HOW EASY IT WAS TO LOCATE PART. HAD RECEIVED THIS MICROWAVE AS A WEDDING GIFT, FEB.1994. THOUGHT I WAS GOING TO HAVE TO REPLACE. THANKS TO YOUR WEBSITE I WAS ABLE TO LOCATE AND PURCHASE THE PART NEEDED TO FIX THE PROBLEM IN LESS THAN 1 MINUTE. I THANKS YOU. I LOVE THIS PARTICULAR MICROWAVE!
Turntable motor was worn out - gears were slipping
- Customer: Chad from Roanoke VA
- Difficulty: Easy
- Time to Complete: 15 - 30 mins
- Tools Required: Screw drivers
- 1 of 2 people found this instruction helpful
The job was very simple, remove the bottom plate of the microwave which is four screws and it exposes the motor. There are two screws which hold the motor in place that you access from inside the unit. Remove the two screws being carefull not to lose the gasket that is in between the motor and the bottom of the unit. Set the new motor in place being sure to add the gasket to the new part and run the two screws to the new motor and tighten! It don't get any easier than that! Also do not forget to plug the motor back into the female socket before attaching the bottom plate!