Models > 4VET18GKGW01

4VET18GKGW01 Whirlpool Refrigerator - Overview

Get Parts and Repair Help for 4VET18GKGW01

If you know the refrigerator repair part you need, you can browse the list of all parts on the 4VET18GKGW01, or you can search by name or part description. You can also find your part by where it is located on the 4VET18GKGW01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for 4VET18GKGW01 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the 4VET18GKGW01 [Viewing 5 of 5]

$3.76

Icemaker Water Fill Tube Kit

This kit comes with a fill tube and a compression nut.

$2.70

SCREW

$6.98

Light Rocker Switch

$3.96

End Cap Trim Piece

$4.65

Touch-Up Paint - White

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$40.02

Door Handle

White handle only. Screws are not included.

$4.06

End Cap Trim - White

$2.70

SCREW

Sold individually.

$97.46

Fresh Food Door Gasket - Misty Beige

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Broken elbow on icemaker water fill tube.

  • Customer: Charles from Orland Hills IL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 72 of 79 people found this instruction helpful
Removed 2 screws holding water fill tube to rear of refrigerator and pulled out, matched old part with new to make sure of proper match. Guide new fill tube thru hole, making sure it is aligned with slot in ice cube tray on inside of freezer. Install new plastic line from water pump outlet to water fill tube, check for leaks, job done. read more

Lights inside refrigerator not working

  • Customer: Clint from Rayville MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 41 of 49 people found this instruction helpful
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again. read more

Light Would Not Go On In The Refrigerator

  • Customer: DANIEL from MINNEAPOLIS MN
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 23 of 27 people found this instruction helpful
First I removed the old lightbulb from the socket and replaced it with a new one to confirm that the bulb was not the problem. I then pryed the socket out with a flat-head screwdriver. I could tell that the socket was anchored in its hole with clips so it was relatively easy to pry it out. Once the socket was out, I disconnected the lead wires and ordered... read more