Models > 4RF315PXDQ0

4RF315PXDQ0 Whirlpool Range - Overview

Get Parts and Repair Help for 4RF315PXDQ0

If you know the range repair part you need, you can browse the list of all parts on the 4RF315PXDQ0, or you can search by name or part description. You can also find your part by where it is located on the 4RF315PXDQ0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for 4RF315PXDQ0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$4.26

Chrome Drip Bowl - 8"

This part has been substituted by the manufacturer and has a hole in the center. It no longer has a solid bottom. Sold individually.

$28.66

Bake Element - 2600W 240V

This closed hinged style bake element is 15-3/4 inches long and 16-5/8 inches wide. The terminal depth is three inches and they are 1-3/4 inches apart.

$3.96

Drip Bowl - 6"

$8.22

Surface Burner Plug-In Block Kit

This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw.

$26.93

Surface Burner - 8" - 2600W

NOTE: The manufacturer recommends that you replace the burner receptacle at the same time.

$24.60

Standard Y-Frame Surface Burner - 6" - 1500W

The manufacturer suggests replacing the receptacle at the same time.

$28.25

Oven Temperature Sensor

This oven temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.

$7.65

Drip Bowl - 6" - Black

Sold individually.

$8.61

8" Drip Bowl - Black

This black porcelain drip bowl with a hole in the bottom is intended for use with some electric ranges and cooktops.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

oven wouldn't heat

  • Customer: Joe from Greeley CO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 468 of 471 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires, then removed element and replaced with new
. read more

Drip bowls were burned and tacky

  • Customer: Donna from Dallas TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 460 of 459 people found this instruction helpful
First I removed the old bowls and replaced them with the new. read more

lower back element stopped working

  • Customer: Bradley from Lexington OK
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 448 of 525 people found this instruction helpful
I got the model number and ordered a replacement element from partselect, was shipped quickly and I installed it in about 30 minutes, it now works great read more