Models > 4KUCC151T4

4KUCC151T4 KitchenAid Trash Compactor - Overview

Get Parts and Repair Help for 4KUCC151T4

If you know the trash compactor repair part you need, you can browse the list of all parts on the 4KUCC151T4, or you can search by name or part description. You can also find your part by where it is located on the 4KUCC151T4 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your trash compactor. We’ve also included any installation videos we have for 4KUCC151T4 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$12.02

15" Compactor Bags - 15 Pack

These bags will fit most 15" rectangular compactors.

$30.39

Drive Gear Kit

This kit is used for trash compactors. It includes both gears, pin spring, C-ring, ram stop, and ram cam.

$8.61

Charcoal Filter

Sold individually.

$2.03

Foot, Front - Single

Sold Individually.

$34.60

Directional Switch

$52.47

Rotary Switch Kit

This kit comes an on-off rotary switch, and two chrome knobs.

$49.80

15" White Plastic Compactor Bags - 60 Pack

$3.86

Touch-Up Paint - White

$11.30

15" Compactor Bag Carrier with Easy Grip Handles

Compactor bags are sold separately.

$13.17

Key

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Old Plastic Compactor Key Became Brittle and Broke

  • Parts Used:
  • Key
  • Customer: Ron from El Paso TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 17 of 21 people found this instruction helpful
Original key part number was 776586 as found underneath the the rim of the broken key. It's known as a compactor key, or a key-knob, but in layman's terms, I would call it the "off-on-start" knob. The replacement part number was 386676, and fits perfectly.
The original key had become old and brittle, and eventually just broke apart. This was a 30... read more

Trash Compactor ram wouldn't lower

  • Customer: Scott from Indianapolis IN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 12 of 13 people found this instruction helpful
I pulled the trash compactor out from under the counter.

I took out the four screws that kept the top cover in place to expose the ram.

The gear shafts were turning but the ram would not lower, at first I though the ram drive bolts were stripped and it wouldn't engage the shaft. Then I realized there was a mechanical directional\limit s... read more

Compactor motor kept running after cycle ran, making alot of noise and unit jumping around.

  • Customer: Keith from Keller TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 10 of 11 people found this instruction helpful
Pulled the Compactor from underneath cabinet, unplugged power. Removed the top plate off compactor to expose the crush piston. Removed the front control panel by removing two phillips screws, wiring and directional (limit) switch is now exposed. Removed the two screws securing switch, removed wiring one wire at a time and replaced on new switch in same posit... read more