4KSRS27QFA01 KitchenAid Refrigerator - Instructions

Easy. Followed directions. Ice bucket is now full. I highly recommend this service (fast shipping) and instructional videos make it a cake walk.

Removed and replaced retaining clip and installed a new strain relief. Parts arrived in 2 days from the time they were ordered. No problems whats-so-ever. Great doing business with Parts Select again.

I bought the part from Part Select and they sent a video on how to install part.

removed old parts from bin and installed new bin

All of the parts are removed and install through the front of the freezer bin. Remove three screws and unplug the old one. I plugged the old wiring directly in and set the new ice maker on two of the screws for alignment, then screwed in the third screw, tightened everything. Install the arm that checks the status of the amount of ice and waited for it to fill up with ice.

took out the old fill tube installed the new one and its working great. I really did not think that was going to be the problem thought it would be more than that but it was not. It took about 7min to change thanks for the fast shipping I will use you in the future.

My husband and I followed the instructional video on how to replace the "direct drive drum". We took note of how everything looked prior to dismantling the ice bin. We made sure we had the proper tools and a large flat surface to work on and started taking out the screws. Replaced the new drive drum part and put it all back together. The whole process took approximately 30 minutes and the ice crusher works great now. I'm a happy camper!!

Unplugged it for a day listened to the ice melting on the inside and plug it in again. Decreased the temperature settings and it now seems to work fine. I will save the part in case I ever need it in the future.

On the left side I unscrewed the screw and replace it with a new one . The right side in had to take s file and file of the rivet. You can use a rivet gun or a metal screw to replaced the clip. Once it is finish open the refrigerator door to see how to line the kick plate into the clip. A piece of cake.

I watched the ice maker installation video and I installed the new ice maker with no problem and was done in less the 30 min. with everything. The ice maker is working great. thank you Fred

Door cams were worn out. Removed food from door. Removed top hinge cover and hinge. Lifted door off lower hinge pin and placed door on a table. Removed old door cam and installed new one. Replaced closing cam on lower hinge. Set door back on lower hinge and closed door (magnetic strips hold the door in place). Reinstalled top hinge and replaced cover.

I receved the new ice maker and the only problem I had was getting the old ice maker plug disconected from the frig.

I followed the really great repair video on this site. I would not have been able to do it without the video. Thanks very much for the video. Once I had the front panel off, it was relatively easy. Definitely would buy here again and attempt repairs myself. Very good experience! Very happy.

I watched a video several time to get the steps in the removal and reinstall. It really was not that hard but first time repairs can take extra time.

turned off power unscrewed all the screw that mount ice maker, used flat head to release the clip on the wire harness, took out and exchanged the overfill wire, plugged the new unit in at wire harness, lined up and leveled ice maker tighten all the mounting screws, very simple repair i am very happy that you still had the orginal (OEM) ice maker, thanks Herb