Models > 4KHWS160AL8

4KHWS160AL8 KitchenAid Hot Water Dispenser - Overview

Get Parts and Repair Help for 4KHWS160AL8

If you know the hot water dispenser repair part you need, you can browse the list of all parts on the 4KHWS160AL8, or you can search by name or part description. You can also find your part by where it is located on the 4KHWS160AL8 by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$18.27

Thermal Fuse

Replace when you're not getting hot water.

$2.70

SCREW

$71.28

Displacer

$3.83

Screw

This screw is sold individually.

$3.83

SCREW

$82.98

VALVE-MECH

$54.95

THERMOSTAT

$41.55

Shell, Tank Lower

$11.90

CONNECTOR

$5.55

BRACKET

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

No Hot Water

  • Customer: Paul from Woodstock GA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers, Wrench set, Wrench(Adjustable)
  • 3 of 3 people found this instruction helpful
I've replaced several Kitchen-Aid hot water dispensers because of no hot water. This time, I decided I'd dig deeper.

I noticed that the thermal fuse was the first item on the Part-Select list. I assumed it was the most frequently ordered part.

I removed the hot water tank from under the sink. I disassembled the tank and shell. I disas... read more

No Hot Water

  • Customer: Paul from Woodstock GA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers, Wrench set, Wrench(Adjustable)
  • 2 of 2 people found this instruction helpful
I've replaced several Kitchen-Aid hot water dispensers because of no hot water. This time, I decided I'd dig deeper.

I noticed that the thermal fuse was the first item on the Part-Select list. I assumed it was the most frequently ordered part.

I removed the hot water tank from under the sink. I disassembled the tank and shell. I disas... read more

No hot water

  • Customer: John from Aurora OH
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 1 of 1 people found this instruction helpful
Unplug unit, turn off water, use 1/4" open end wrench to push down on collet holding in copper tubing - pull out copper tubing (per instructions in units manual), use pliers to squeeze clamp on water deliver plastic tube and remove. Bring unit up on counter, remove three screws holing top on and also remove on/off/temp knob and two screws holding nameplate t... read more