Models > 4GWTW4800YQ1

4GWTW4800YQ1 Whirlpool Washer - Overview

Get Parts and Repair Help for 4GWTW4800YQ1

If you know the washer repair part you need, you can browse the list of all parts on the 4GWTW4800YQ1, or you can search by name or part description. You can also find your part by where it is located on the 4GWTW4800YQ1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for 4GWTW4800YQ1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.32

Agitator Directional Cogs

These agitator directional cogs are commonly referred to as dog ears. They come four to a package and are usually used with direct drive washing machines.

$8.07

Agitator Cam Kit

This kit included the cam, 4 dogs and bearing.

$2.18

Inner Cap Seal

Also known as an O-Ring.

$3.76

Agitator Cap Barrier with Seal

$2.70

Screw

This screw is sold individually.

$2.70

Hose Clamp

$3.76

Thrust Spacer

Sits in between the agitator base and upper agitator.

$5.54

Touch-Up Paint - White

$68.43

Agitator

This agitator comes with the 4 agitator dogs (cogs) and top mover. The cap is NOT included with the agitator.

$3.96

WASHER

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

washer wouldn't agitate

  • Customer: mike from Kent WA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 474 of 479 people found this instruction helpful
First pry off the cap of the agitator. Then using a socket remove the bolt that holds the plastic cup in place. Remove this cup by prying it loose from the two tabs that hold it in place. Once this cup is removed you can get to the broken cogs.
Slip the new cogs into the underside of the cup, and slide the cup back down in the agitator housing usin... read more

top half of agitator did not move during wash cycle

  • Customer: dennis from new stanton PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Socket set
  • 174 of 198 people found this instruction helpful
pull off softner dispenser, pop off agitator cap by inserting straight screw driver into small slot, remove bolt inside agitator with socket wrench and long extension, pull agitator straight up off shaft, place agitator on floor, with feet holding bottom half pull top half apart from bottom half by pulling straight up, note direction of old cogs remove and r... read more

Dog ears worn down; upper agitator not moving

  • Customer: shawn from la jolla CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 46 of 50 people found this instruction helpful
Pulled off the dispenser. Used socket set to remove bolt. Removed entire agitator out of washer. Placed both feet on bottom of agitator and then pulled up on the upper agitator. It took some muscle due to the years of washer use. I used a flat-head screwdriver to weaken the plastic clips holding down the old bearing-driven cam. Once I got the upper agi... read more