Models > 4ET18ZKXDW01

4ET18ZKXDW01 Whirlpool Refrigerator - Overview

Get Parts and Repair Help for 4ET18ZKXDW01

If you know the refrigerator repair part you need, you can browse the list of all parts on the 4ET18ZKXDW01, or you can search by name or part description. You can also find your part by where it is located on the 4ET18ZKXDW01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for 4ET18ZKXDW01 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$53.82

Crisper Pan

$7.28

Light Rocker Switch

$3.96

End Cap Trim Piece

$16.04

Crisper Drawer Rail

$7.41

Door Shelf End Cap - Left or Right Side

Sold Individually.

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$3.86

Touch-Up Paint - White

$8.76

Refrigerator Shelf End Cap - White

$28.51

Light Socket Kit

The bulb is sold separately.

$4.06

End Cap Trim - White

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Lights inside refrigerator not working

  • Customer: Clint from Rayville MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 31 of 38 people found this instruction helpful
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again. read more

Missing center track for crisper drawers

  • Customer: JR from Portland OR
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 16 of 17 people found this instruction helpful
Remove the glass shelf and the support frame. Bend the front clip on the track back far enough to fit into slot on frame. Insert the back end of the track into the opening at the back of the frame. Press the front end of the track into the retainer slot in the frame. Reinstall the frame and glass shelf. Done. read more

The rubber piece around it was worn out

  • Customer: Carmen from Albany NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 15 of 19 people found this instruction helpful
We just had to find the trick to put it in where it would catch on and the rest was a piece a cake.

You had to put it in the groove where it would catch and snap it in place and the rest went in
pretty easy. read more