Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 4ET18NKXFW00

4ET18NKXFW00 Whirlpool Refrigerator - Overview

Get Parts and Repair Help for 4ET18NKXFW00

If you know the refrigerator repair part you need, you can browse the list of all parts on the 4ET18NKXFW00, or you can search by name or part description. You can also find your part by where it is located on the 4ET18NKXFW00 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for 4ET18NKXFW00 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the 4ET18NKXFW00

[Viewing 5 of 5]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$56.37

Crisper Drawer

This crisper drawer is clear plastic. Sold individually.

$11.43

Light Rocker Switch

This light switch is triggered by the door opening and closing.

$10.76

Door Shelf End Cap - Left or Right Side

Sold Individually.

$4.67

End Cap Trim Piece

Sold individually.

$16.11

Crisper Drawer Rail

This part goes in the center of the crisper shelf and acts as a support.

$11.64

Ice Pan

This part may come in white or clear plastic, but either will still work and fit properly in your appliance.

$4.89

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$20.80

Compartment Door

$7.20

Touch-Up Paint - White

18ml

$5.54

Screw

Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Lights inside refrigerator not working

  • Customer: Clint from Rayville, MO
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 62 of 74 people found this instruction helpful
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again. read more

Light Would Not Go On In The Refrigerator

  • Customer: DANIEL from MINNEAPOLIS, MN
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 51 of 58 people found this instruction helpful
First I removed the old lightbulb from the socket and replaced it with a new one to confirm that the bulb was not the problem. I then pryed the socket out with a flat-head screwdriver. I could tell that the socket was anchored in its hole with clips so it was relatively easy to pry it out. Once the socket was out, I disconnected the lead wires and ordered... read more

The door gasket had worn out and the door wouldn't shut properly

  • Customer: Jo from Hudson, NH
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 24 of 29 people found this instruction helpful
We took the edge out of the slot and pulled the old one off then put the new one on. Once we got the plastic edge started into the slot it was a breeze. Only took about 5 minutes. We were very pleased with the results. read more