Models > 47-2707-00-01

47-2707-00-01 Frigidaire - Overview

Get Parts and Repair Help for 47-2707-00-01

If you know the repair part you need, you can browse the list of all parts on the 47-2707-00-01, or you can search by name or part description. You can also find your part by where it is located on the 47-2707-00-01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your . We’ve also included any installation videos we have for 47-2707-00-01 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$19.92

Rear Drum Bearing Kit

This kit includes one bearing, one ball shaft, one ball bearing, one ball bearing retainer, a small tube of high temperature lubricant and installation screws.

$2.77

Drum Support Bearing

$3.22

Door Latch Kit

This door latch kit comes with the strike and the catch.

$23.71

Door Catch

$8.29

Bearing Bracket

$0.50

Levelling Leg

$6.93

Grounding Ball

$11.14

Flat Style Belt

This is a flat style ridgeless dryer belt.

$9.82

Idler Pulley Assembly

Use this idler pulley assembly with gas or electric clothes dryer that has a flat dryer belt. ***Please NOTE: This part has been redesigned by the manufacturer and may not fit you...

$29.57

Seal

Adhesive is sold separately.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Loud Squeaking

  • Customer: Frank from Boyertown PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 244 of 252 people found this instruction helpful
1. Unplug dryer from outlet
2. Using Lg. flat screwdriver, pry under the front edge of the top and release two spring tabs
3. Lift up top and tilt back out of your way
4. Unscrew two phillips scews on inside of front panel
5. Lift up and out the front panel. Two spring clips at bottom.
6. Rlease tension on drum belt at the motor. Acc... read more

bearing and heating element broke

  • Customer: Kevin A Frech from Sidney IA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 56 of 80 people found this instruction helpful
Had to first remove the top of the dryer this was done by removing the clamps on the back. Next I removed the front of the dryer by removing the two nuts the frong in the inside, these are somewhat hard to reach. Next the drum was removed. then the heating element shield. Replaced, the heating element then secured it into place. replaced the drum bearin... read more

Catch broke, door wouldn't stay closed.

  • Customer: Dianne from Kansas City MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 34 of 35 people found this instruction helpful
Used a screwdriver to pop out broken piece. Used pliers to snap in new one. read more