Models > 46-2857-00-02

46-2857-00-02 Frigidaire Washer - Overview

Get Parts and Repair Help for 46-2857-00-02

If you know the washer repair part you need, you can browse the list of all parts on the 46-2857-00-02, or you can search by name or part description. You can also find your part by where it is located on the 46-2857-00-02 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for 46-2857-00-02 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$17.91

Water Inlet Valve

This washing machine water inlet valve has two ports for water to enter.

$4.95

Touch Up Paint

This 18 ml bottle of white appliance touch up paint is a little over two inches tall. It can be used for refrigerators, microwaves, ranges, clothes dryers, and freezers.

$25.23

High Temperature Adhesive

Used for installing felt and rubber seals on dryers.

$4.30

Single Tub Cover Clip

$7.04

Upper Spin Bearing Washer

$8.09

BOLT

$18.46

CLAMP

$14.87

1=1PC, HH FAB SOFTNER

$10.68

PLATE

$408.68

Transmission Assembly

This part aids in the spinning or agitating cycles.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

washer continued to fill to point of overflow

  • Customer: alvaro from east hampton NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 35 of 40 people found this instruction helpful
FIRST I REMOVED THE TOP PANEL HELD BY FOUR SCREWS AT REAR OF PANEL, PULLING THE PANEL FOWARD AND UP. THEN DISCONNECTED THE POWER AND WATER CONNECTIONS. THEN I REMOVED THE TWO SCREWS HOLDING THE FLOW VALVE TO THE WASHER REAR PANEL,PULLED THE VALVE FOWARD ,REMOVED THE TWO ELECTRIC CONNECTORS, PINCHED THE WATER CLAMP WITH PLIERS AND REMOVED THE WATER CONNECTI... read more

water continued to flow into machine during spin cycle

  • Customer: Howard from Lcolnton GA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 10 of 11 people found this instruction helpful
After moving machine to an area that allowed easy access to the unit, disconnected the water supply hoses from the inlet valve.
Removed the two screws that keep the back in place, removed the clips that keep the top in place, moved the top over far enough to get the valve out. Removed the screw that keeps the inlet valve in place, disconnected the power... read more

NO COLD WATER

  • Customer: Mark from Pittsburgh PA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 7 of 8 people found this instruction helpful
CHECKED PROBLEM ON-LINE AND DISCOVERED IT WAS THE WATER INLET VALVE. MATCHED THE PART ON PART SELECT.COM. FINDING THE PART WAS VERY EASY. PART SELECT HAD A GRID BEHIND THE PICTURE TO HELP DETERMINE THE SIZE AND PICTURES FROM ALL SIDES. REMOVING THE OLD PART, MATCHING IT, AND REPLACEMENT TOOK A TOTAL OF 30 MINUTES. I NOW HAVE CLEAN CLOTHES. read more