Models > 41729052990

41729052990 Kenmore Washer - Overview

Get Parts and Repair Help for 41729052990

If you know the washer repair part you need, you can browse the list of all parts on the 41729052990, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for 41729052990 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$34.29

Shock Absorber Kit

This kit is used for front load washers and includes 2 dual-stage shock absorbers, 1 spare shock mounting pin and 4 locking nuts. These shock absorbers keep the washer from vigorou...

$12.95

Door Catch

This washer door catch is a replacement from the original. This is only available in black.

$17.91

Water Inlet Valve

This washing machine water inlet valve has two ports for water to enter.

$102.92

Drain Pump - 60Hz 120V

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

$27.71

Single Spring with Insulators

$15.15

Drain Hose

This part comes with a ninety degree elbow.

$19.49

Drive Belt - 6 ribs

$5.50

SCREW

$69.43

Bellow with Clamp

Also known as the door boot seal. This part is used to keep the clothes inside the tub during the wash cycle. The folds in the bellow allow the tub to move separately from the do...

$45.12

Tub-To-Pump Hose

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The door catch broke and the door would not close.

  • Customer: Maryann from Sandy Hook CT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 469 of 472 people found this instruction helpful
First, I had to remove 2 screws to take off the 2 broken pieces of the door catch. Then I put the new one on using the same 2 screws. The door is now able to close, but does not lock properly. In order to make it work, I put a thin piece of rubber into the place where the door meets the machine. This causes the lock to engage and the machine to work. I ... read more

Drum making loud noise

  • Customer: Scott from Riverview FL
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
  • 97 of 115 people found this instruction helpful
Turned out drum brackets were corroded, so drum and shell-rear/brg and gasket needed replacing

1. Disconnect power and water lines
2. Remove rear and top panels
3. Remove control knobs, Assembly, soap dispenser, and Assembly cons frame/trim
4. Remove all screws from control panel mounting bracket (panel-cont mtg wing bend), disc... read more

Both vibration shock absorbers broken

  • Customer: Douglas from Medical Lake WA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Socket set
  • 90 of 97 people found this instruction helpful
removed 2 screws and removed top access cover. removed 2 screws and removed front access cover. removed 4 retaining pins (one with nammer and punch because it was stuck) connected lower ends of new shocks with plastic pins, extended each shock to slip fit and connected upper ends to wash tub mounts. Reinstalled panels. I wish I could say that it all went w... read more