Models > 3XART718F00

3XART718F00 Whirlpool Refrigerator - Overview

Get Parts and Repair Help for 3XART718F00

If you know the refrigerator repair part you need, you can browse the list of all parts on the 3XART718F00, or you can search by name or part description. You can also find your part by where it is located on the 3XART718F00 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for 3XART718F00 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the 3XART718F00 [Viewing 5 of 5]

$53.82

Crisper Pan

$3.96

End Cap Trim Piece

$2.70

SCREW

$7.42

Light Rocker Switch

$12.52

Crisper Drawer Rail

$7.41

Door Shelf End Cap - Left or Right Side

Sold Individually.

$4.95

Touch-Up Paint - White

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$4.06

End Cap Trim - White

$88.78

Fresh Food Door Gasket

This white door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Lights inside refrigerator not working

  • Customer: Clint from Rayville MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 39 of 47 people found this instruction helpful
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again. read more

Light Would Not Go On In The Refrigerator

  • Customer: DANIEL from MINNEAPOLIS MN
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 21 of 25 people found this instruction helpful
First I removed the old lightbulb from the socket and replaced it with a new one to confirm that the bulb was not the problem. I then pryed the socket out with a flat-head screwdriver. I could tell that the socket was anchored in its hole with clips so it was relatively easy to pry it out. Once the socket was out, I disconnected the lead wires and ordered... read more

The rubber piece around it was worn out

  • Customer: Carmen from Albany NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 20 of 27 people found this instruction helpful
We just had to find the trick to put it in where it would catch on and the rest was a piece a cake.

You had to put it in the groove where it would catch and snap it in place and the rest went in
pretty easy. read more