Models > 3WSC19D4AY00

3WSC19D4AY00 Whirlpool Refrigerator - Overview

Get Parts and Repair Help for 3WSC19D4AY00

If you know the refrigerator repair part you need, you can browse the list of all parts on the 3WSC19D4AY00, or you can search by name or part description. You can also find your part by where it is located on the 3WSC19D4AY00 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for 3WSC19D4AY00 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$57.43

Water Filter

Sold individually.

$23.19

Ice Bin Auger Drum

This white ice bin auger drum comes with a washer.

$9.82

FILTER-AIR

$5.54

Touch-Up Paint - White

$3.56

Water Tube Kit

This tubing is 1/4'' in diameter and comes with 2 inserts. This tubing may be longer than the original, and may have to be cut.

$2.70

SCREW

Sold individually.

$4.46

Thimble Top - white

For white, biscuit, black and stainless models.

$2.70

Screw

This screw is sold individually.

$9.73

Ice Dispenser Motor Coupling

This part attaches to the drive shaft of the ice dispenser motor.

$24.55

Fan Blade

Used with Evaporator Fan Motors.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Plastic bits dispensed from Ice Dispenser in Door

  • Customer: john from seaford VA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set
  • 100 of 110 people found this instruction helpful
Removed Ice bin from Fridge

Removed all bolts on bin with nut driver...about six

Removed housing...be careful with spring on crusher/cube control rod

Removed C clamp on end of auger with small slotted screw driver and needle nose pliers.

Removed plastic nut on end of auger shaft

Removed Ice crusher jaws ... read more

plastic Ice bin auger broke and needed to be replaced

  • Customer: Suzanne from Colorado Springs CO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 30 of 31 people found this instruction helpful
The repair was actually easy; however I have an ice dispencer/crusher attached and the which the diagram supplied with the part did not include. I had to make several calls before I was e-mailed the diagram.
Suggestions: note that the screw at the end of the auger goes in the reverse direction (this took me about 20 minutes to figure out even though... read more

Had to replace a hose connector at the base of my refrig/frreezer

  • Customer: Leo from Salem SC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 23 of 39 people found this instruction helpful
Perhaps a helpful hint:

When aI received the hose adapter/connector, I inserted the 2 hose ends only to have water drip from the connection.
I used a utility knife to remove an inch from each side, then reinserted the hoses. That made the differnce. Dry as a bone.

LG read more