Models > 37-0007-23-07

37-0007-23-07 Frigidaire Range - Overview

Get Parts and Repair Help for 37-0007-23-07

If you know the range repair part you need, you can browse the list of all parts on the 37-0007-23-07, or you can search by name or part description. You can also find your part by where it is located on the 37-0007-23-07 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for 37-0007-23-07 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the 37-0007-23-07 [Viewing 5 of 5]

$3.51

Drip Bowl - 8"

$4.54

Drip Bowl - 6"

This six inch heavy chrome drip bowl is compatible with electric ranges that utilize plug-in surface burners. This bowl has a narrow 3/8 inch lip.

$18.02

Surface Element - 8" - 220V

4 Turn.

$18.68

Surface Element - 6"

$3.51

Main Terminal Block Kit

$27.87

Burner Switch Kit

$27.02

Surface Burner Terminal Block Kit

This kit includes the terminal block, mounting bracket, contact with wires and wire nuts. It provides a way of connecting individual electrical wires and offers protection of the ...

$35.95

Door Hinge - Left Side

This hinge is located on left side of the oven door.

$34.04

Hinge - Right Side

$7.25

Hex Nut

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Cord was not tightened enough by delivery crew.

  • Customer: Timothy from Spring Valley AL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 29 of 51 people found this instruction helpful
PF alarm appeared on display. Noticed clicking when cord was moved. Had arced for some time and melted original block. New part slightly different. Only has 3 lugs, old one had six. Stack using washers provided. Take note of colors before disassembly. Use caution while working through access opening. The edges are sharp. Only tools needed are phillips screw... read more

High heat reluctant to turn down.

  • Customer: George from New Port Richey FL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 16 of 19 people found this instruction helpful
Most of the job is simple fastener mechanics.
Use a nut driver or Phillips screwdriver. Remove rear panel.

Pull out control knob. If it is stuck, wrap a small rag around the back of it and pull the rag steadily.

Carefully match marked terminals on the replacement switch with those on original. Switch terminals may not be in the sa... read more

Right front burner would over-heat

  • Customer: Melvin from Attica MI
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 13 of 16 people found this instruction helpful
First of all I removed the top panel then removed the switch. I then took pictures of the switch & drew a sketch with all the info. Then I went to your web site, matched up the switch & ordered.
When the switch arrived I went thru the above replacing the bad switch. read more