This is a burner grate for your surface burner, and it is compatible with your range stove top. The purpose of this part is to provide a balanced and stable surface for you to set your cookware on whi...
This is white touch up paint for refrigerators, microwaves, ranges, dryers, and freezers. It is used to cover, or touch up, nicks and scratches on the appliance from wear and tear. It is an 18ml bottl...
This main top assembly is located on top of your range/oven to protect and house the burners. The main top also acts as a stable surface for cookware and cooking dishes. If your main stop is off balan...
This is a bulb clip, also known as a sensor clip or bulb holder, which is designed to hold the thermostat bulb in place within the interior of various models of ovens. This clip is made of metal, meas...
The new part arrived quickly and well-packaged. Removing the old top was easy enough, but needed to remove the legs (that hold it in an open position for cleaning) from the old top. The sheet metal screws holding one of them in place were rusted in place. Had to loosen with WD-40 and vice grips, but got them off without breaking or stripp
... Read moreing the threads. They installed perfectly on the new top and the top slipped into place easily.
First I had to slide the stove out of its cubby and then I removed the two screws holding on the shield. I next removed the wires going to the spark module. I removed the top screw and loosened the bottom one. Installed the new spark module in reverse order. Less than 15 minutes for whole repair. Still have problems with spark module
... Read more not working if oven is on, but I think it is because there is no air circulation behind the stove.
I propped up the old one, the way you do to clean under the top, and removed the screw on either side of the prop up post. I slid off the top and then removed the vent so I could clean it and put it on the new top. I replaced the vent into the new one, put the props back in and then the screws. It may have gone faster for someone else-I a
... Read morem a woman of 68 years of age and struggled a little with it. All in all, it went very well.