Models > 32 0027 23 03

32-0027-23-03 Frigidaire - Overview

Get Parts and Repair Help for 32-0027-23-03

If you know the repair part you need, you can browse the list of all parts on the 32-0027-23-03, or you can search by name or part description. You can also find your part by where it is located on the 32-0027-23-03 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your . Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$48.36

Flat Style Oven Igniter

This flat style gas oven igniter has an amperage range between 3.2 to 3.6.

$35.95

Door Hinge - Left Side

This hinge is located on left side of the oven door.

$34.04

Hinge - Right Side

$39.80

SPARK MODULE

$3.27

SCREW

$154.02

Oven Safely Valve

Comes with gas line adaptor and orifice. This part make sure that no gas is released until the igniter gets enough power to ignite the gas range.

$52.37

Rear Top Burner

$137.62

Gas Pressure Regulator

***No Conversion Kit Required - Adjust On Appliance*** This valve automatically cuts off the flow of a liquid or gas when it reaches a certain pressure.

$41.63

ROLLER

IGNITOR

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven quit heating.

  • Customer: John from Darlington SC
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 374 of 378 people found this instruction helpful
After reading up on the problem of the gas oven not lighting I decided I needed to install a new igniter. I had read where some people just pulled a panel off the back and installed a new one.. yeah, no such luck with this model so I had to crawl into the broiler drawer space [which I had to clean out first]. Note, if you wear trifocal glasses you might as ... read more

Oven was difficult to light, then stopped lighting altogether

  • Customer: Ritchie from Ithaca NY
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 185 of 261 people found this instruction helpful
1. Turned off circuit breaker to stove
2. Removed the two screws holding down the floor of the oven (screws are at back.), and then lifted it out.
3. Removed the nut holding down the flame guard, and lifted it off.
4. Opened the bottom drawer.
5. Removed the protective cover in the back left of the oven at the bottom, first removing the ... read more

Oven took too long to Light. House smelled like Gas!

  • Customer: JOHN from LA MESA CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 106 of 172 people found this instruction helpful
Turned Off Breaker!
Removed 2 screws that held Igniter in place.
Cut Old Wires Free
Marked location to old igniter with tape so I didn't cross connect.
Stripped new wire ends.
Used Wire Nuts to connect New part (provided).
Installed New Igniter with 2 screws.
Flipped Breaker On.
Tested
WORKS PERFECT.

Sa... read more