Models > 2VET20NKJN01

2VET20NKJN01 Whirlpool Refrigerator - Overview

Get Parts and Repair Help for 2VET20NKJN01

If you know the refrigerator repair part you need, you can browse the list of all parts on the 2VET20NKJN01, or you can search by name or part description. You can also find your part by where it is located on the 2VET20NKJN01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for 2VET20NKJN01 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the 2VET20NKJN01 [Viewing 5 of 5]

$53.82

Crisper Pan

$2.70

SCREW

$6.98

Light Rocker Switch

$3.96

End Cap Trim Piece

$7.41

Door Shelf End Cap - Left or Right Side

Sold Individually.

$12.00

Crisper Drawer Rail

$4.65

Touch-Up Paint - White

$87.04

Fresh Food Door Gasket

This white door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

$40.02

Door Handle

White handle only. Screws are not included.

$4.06

End Cap Trim - White

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Temperature unstable

  • Customer: Duane from Albany OR
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 43 of 54 people found this instruction helpful
Open the door. Removed two screws holding the cover of the thermostat. There is a clip which holds the thermostat in place. Remove the clip. Take out the thermostat. Remove the thermocouple (the long grey metal with the coil at the end) which is also held in place by a clip. Replace with the new thermostat and thermocouple and clip into place. Replace t... read more

Lights inside refrigerator not working

  • Customer: Clint from Rayville MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 41 of 49 people found this instruction helpful
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again. read more

Light Would Not Go On In The Refrigerator

  • Customer: DANIEL from MINNEAPOLIS MN
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 23 of 27 people found this instruction helpful
First I removed the old lightbulb from the socket and replaced it with a new one to confirm that the bulb was not the problem. I then pryed the socket out with a flat-head screwdriver. I could tell that the socket was anchored in its hole with clips so it was relatively easy to pry it out. Once the socket was out, I disconnected the lead wires and ordered... read more