Models > 2LA5700XMW1

2LA5700XMW1 Whirlpool Washer - Overview

Get Parts and Repair Help for 2LA5700XMW1

If you know the washer repair part you need, you can browse the list of all parts on the 2LA5700XMW1, or you can search by name or part description. You can also find your part by where it is located on the 2LA5700XMW1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for 2LA5700XMW1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$19.95

Dryer Door and Washer Lid Switch Kit

This kit is simple on/off mechanism that prohibits the machine from operating when the door is open.

$2.70

Screw

This screw is sold individually.

$2.70

Hose Clamp

$5.54

Touch-Up Paint - White

$2.92

Centerpost Gasket

Also known as Main Outer Tub Seal. This part helps to prevent leaking from the bottom of the tub.

$2.03

Lid Hinge Mounting Screw

Sold individually.

$2.70

Hose Clamp

This hose clamp is sold individually.

$2.70

Top Panel Lock

$2.48

Lid Bumper

This gray and white washer lid bumper contains a rubber bottom and is sold individually.

$15.94

Drive Block - 2 5/16" High

This part is for large capacity belt drive and direct drive appliances.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

leaking from tub

  • Customer: Debra from Milton - Freewater OR
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers, Socket set
  • 18 of 20 people found this instruction helpful
First I turned off the water and unplugged the washer from the outlet. I took the two screws off the console and turned it up to undo the clips that hold the cabinet to the back. I took out the 2 phillips screws at the top corners of the back. I was then able to pull cabinet off and not have to remove the console, but carefully slid it to the side, as ther... read more

Lid closes, switch wouldn't turn on machine.

  • Customer: Kenneth from Wilmington IL
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 14 of 17 people found this instruction helpful
Used toothpick for a year to push switch acctuator far enough to engage switch. Broke my foot and found time to order part thru PartSelect. Went from cast to boot and received part 2 days after ordered. Had difficulty with foot and getting to switch. Went back into PartSelect and figured out how to dis-assemmble panels thru the diagrams. Time on my job doesn... read more

Washer would not spin on any cycle. The pump still work so it was not the belt.

  • Customer: Richard from Newark DE
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 14 of 19 people found this instruction helpful
The wig wag selenoid was not shifting the transmission to the spin mode. Using a 5/16 nut driver remove the two screws holding the back access panel. Using the same driver remove the set screw holding the wig wag onto the shaft. Lift the part off the shaft. If it is hard, using a small pry bar. Install new part and reverse the process. read more