Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 2DWTW5500XW1 > Parts

2DWTW5500XW1 Whirlpool Washer - Parts

All parts for the Whirlpool Washer 2DWTW5500XW1

Below is a list of all parts for the Whirlpool Washer 2DWTW5500XW1. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the 2DWTW5500XW1
1-14 of 120
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$48.05

Lid Latch Assembly

The point of the lid switch is for the tub to stop spinning when the washer lid is opened. It is a safety precaution just in case someone decides to stick their hand inside the wa...

$33.17

Clutch Assembly

$3.02

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$3.02

Lid Hinge Mounting Screw

Sold individually.

$50.48

Shift Actuator - 120V 60Hz

This part changes the transmission from agitation to spin mode.

$4.89

D-Shaped Knob Insert

This insert is sold individually. Knob not included. Knob is sold separately.

$6.36

Touch-Up Paint - White

This touch-up paint can be used on a wide variety of household appliances. It is most often used on washers, dryer, refrigerators, dishwashers, ranges, freezers, trash compactors, ...

$9.56

INLET HOSE

This hose can handle hot or cold water and is five feet long.

$25.67

Strike

$5.51

Hose Clamp

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be careful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

$5.73

Washer

This part goes on the agitator retaining bolt.

$4.89

Lid Bumper

This gray and white washer lid bumper contains a rubber bottom and is sold individually.

$2.94

Screw, 11-16 x 3/4

$58.11

Cold Water Inlet Valve

All Parts for the 2DWTW5500XW1
1-14 of 120