Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 28FA-7CXWV8 Maytag

28FA-7CXWV8 Magic Chef Microwave Oven Combo - Overview

Get Parts and Repair Help for 28FA-7CXWV8

If you know the microwave oven combo repair part you need, you can browse the list of all parts on the 28FA-7CXWV8, or you can search by name or part description. You can also find your part by where it is located on the 28FA-7CXWV8 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave oven combo. We’ve also included any installation videos we have for 28FA-7CXWV8 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

$6.16

Light Bulb - 40W

Sold Individually.

$8.84

Surface Burner Receptacle Kit

This kit comes with one ceramic block, metal bracket, wires, and hi-temp wire nuts.

$22.14

SWTCH-LITE

$4.89

SCREW

Latch Lever Clip

$53.22

Oven Door Gasket

$29.02

Hinge - Left Side

The hinges allow the door to swing up and down. The hinges must be properly adjusted in order for the door to close properly.

$27.40

SWITCH- MI

$4.53

RECEPTACLE

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Stove top element not working due to bad receptacle.

  • Customer: Richard from Carthage, NC
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 138 of 149 people found this instruction helpful
Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the new wires with the ceramic wire nuts provided and secured the receptacle back in place with the new screw provided in the kit.
My sister's husband wanted to... read more

Inner Oven Glass broken

  • Customer: David from Wayne, NJ
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 25 of 33 people found this instruction helpful
I removed two retainer screws which released the outside panel.
Next I removed 2 screws which hold the middle glass pane from one of its retainer brackets.
The was another panel with 4 screws to remove before reaching the final glass inner assembly.
Once that panel was reoved with the broken glass it was time to put the repacement glass assemb... read more

Burned terminal block and filter board

  • Customer: Joseph from Decatur, GA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set, Wrench set
  • 56 of 127 people found this instruction helpful
Removed and replaced above named parts, rewired.Be sure to tighten all nuts that secure wires. I believe this is what caused the problem. read more