Models
>
2538290511
2538290511 Kenmore Freezer - Overview
Sections of the 2538290511
[Viewing 4 of 4]
Keep searches simple, eg. "belt" or "pump".
Gasket Retainer Clip Kit - 24 Pieces
PartSelect #: PS469567
Manufacturer #: 5303922007
This gasket retainer clip kit is for freezers. There are 24 pieces in this kit. The clips are what secure the gasket and liner to the freezer lid. The clips are white in color and made of plastic. If ...
$56.11
In Stock
Shelf Support - Right Side
PartSelect #: PS977265
Manufacturer #: 297001500
This is a shelf support for freezers. It is used to help hold the inside of the shelf from both sides (left and right.) Please note: right and left side of shelf support are sold separately. If the sh...
$14.50
In Stock
Shelf Support - Left Side
PartSelect #: PS977266
Manufacturer #: 297001600
This is a shelf support for the left side of a freezer. It is used to help support the inside of the shelf from both sides. *Please note: right and left side of shelf support are sold separately. If t...
$14.50
In Stock
Compressor Start Relay
PartSelect #: PS426380
Manufacturer #: 216594300
The compressor start relay attaches to the compressor in your refrigerator. If your refrigerator will not start, one of the most common parts to fail is the compressor start relay. Sometimes called th...
$22.66
In Stock
SUPPORT-REAR SHELF
PartSelect #: PS425924
Manufacturer #: 216474600
This part is found in freezers. The stud may have broken over time and may no longer be supporting the shelf. If your shelf is not staying in place or you are not able to adjust heights, it may be due...
No Longer Available
Questions And Answers for 2538290511
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the 2538290511
[Viewing 3 of 3]Frost buildup
Fixed by
these parts
these parts
Show All
Won’t start
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
The compressor would not run.
I removed the cover, used a multimeter to test the compressor circuit, and found the compressor start relay to be defective.
Ordered a new one and installed it when it arrived.
Ordered a new one and installed it when it arrived.
Parts Used:
-
Linda from Gurnee, IL
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
18 of 26 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Compressor was short cycling
Removed the cowling with a square drive screw driver, removed the spring clip from the cover of the compressor controls with a screw driver, pulled off the old compressor start relay and replaced it with the new part. Since other problems could have caused the compressor to short cycle this was a "replace the part and hope it would work"
... Read more
since that would be the most common reason and it was not a very expensive part.
Read less
Parts Used:
-
Sherman from Tuttle, OK
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
11 of 16 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
refrigerator stopped cooling
After the refrigerator stopped cooling, we determined that the problem was in the compressor area. we used a screwdriver to get the cover off and then vice grips to get the actual pieces out (start relay & overload)--they broke, but they were already broken). We went to the Home Depot site to purchase the parts, but found PartSelect to b
... Read more
e much less expensive. Put the parts in when they came a few days later and it worked! thank you PartSelect!
Read less
Parts Used:
-
Lisa from Los Angeles, CA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Screw drivers
11 of 23 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!