Models > 2538089

2538089 Kenmore Refrigerator - Overview

Get Parts and Repair Help for 2538089

If you know the refrigerator repair part you need, you can browse the list of all parts on the 2538089, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for 2538089 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$21.30

Water Inlet Valve

When energized, this part releases water from the supply line into the ice mold.

$101.76

Replacement Ice Maker

This part is the replacement heat-release ice maker unit only. This kit comes with four round female connectors at the end of the wire harness. It also comes with the adaptor that converts the harness to three round female and one round male connectors.

$120.46

Ice Maker Assembly

$5.43

ICE STRIPPER

This part is attached to the mold to prevent the ice pieces from falling back into the mold.

$7.45

GEAR

This icemaker drive gear is for the ejector blades

$5.61

Hex Head Screw

Sold individually.

$18.50

Water Fill Tube

This water fill tube supplies water to the icemaker.

$6.34

Shutoff Arm Spring

$38.20

Micro Switch

This part aids in the dispensing of ice or water.

$25.27

Icemaker Thermal Cut-Off

This part is a one-time limit fuse used as a safety device. Once tripped, this part must be replaced.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

ICE MAKER STOPPED WORKING

  • Customer: JACK from MESA AZ
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 84 of 90 people found this instruction helpful
IT WAS PRETTY STRAIGHT FORWARD. REMOVE THE TWO SCREWS THAT HOLD THE UNIT TO THE WALL OF THE FREEZER. IN MY CASE, I HAD TO USE A DIFFERENT ICE MAKER THAN WHAT CAME WITH THE FRIG. IN ORDER TO INSTALL THE REPLACEMENT UNIT THEY SENT A WIRE ADAPTOR SO IT WOULD ATTACH TO THE EXISTING WIRING. THAT TOO WAS ALL FINE AND DANDY. THE ONLY PROBLEM WAS THAT THE END O... read more

Broken ice maker

  • Customer: Juan from Miami FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Socket set
  • 81 of 113 people found this instruction helpful
Unplugged faulty ice maker, removed two screws holding it to the refrigerator and took it out. Reversed the operation with the new ice maker and after a few minutes presto, we have ice. read more

Ice maker died!

  • Customer: John from Las Vegas NV
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Socket set
  • 23 of 25 people found this instruction helpful
The repair for this was very simple, although it was a tight squeeze. The model I replaced the ice maker on was a side by side. First I removed the ice bucket so I could have more room to work with. Then I unscrewed 2 screws on the left side wall holding the ice maker in place. These screws had a 1/4" nut top on them so I used my socket driver for this. T... read more