Models > 2537419440R

2537419440R Kenmore Refrigerator - Overview

Get Parts and Repair Help for 2537419440R

If you know the refrigerator repair part you need, you can browse the list of all parts on the 2537419440R, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for 2537419440R parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$24.87

Drawer Support Rail - Right Side

This drawer track supports the right hand side of the sliding drawer.

Order within the next 5 hrs and your part ships today!
$26.05

Door Shelf Retainer Bar

Sold individually.

Order within the next 5 hrs and your part ships today!
$17.07

Defrost Timer - 60Hz 120V

This defrost timer will cycle for thirty minutes after every eight hours of run time.

Order within the next 5 hrs and your part ships today!
$25.18

Drawer Support Rail - Left Side

This drawer rail supports the left hand side of the sliding drawer.

Order within the next 5 hrs and your part ships today!
$56.46

Door Gasket - White

This fresh food door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air outside.

Order within the next 5 hrs and your part ships today!
$14.79

Defrost Thermostat

The thermostat senses that the heat near the cooling coils has reached the desired temperature.

Order within the next 5 hrs and your part ships today!
$21.30

Water Inlet Valve

When energized, this part releases water from the supply line into the ice mold.

Order within the next 5 hrs and your part ships today!
$40.35

Evaporator Fan Motor Kit - 120V 60Hz

This kit includes the motor, clips and terminal connectors. This part has been updated by the manufacture. This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Order within the next 5 hrs and your part ships today!
$101.76

Replacement Ice Maker

This part is the replacement heat-release ice maker unit only. This kit comes with four round female connectors at the end of the wire harness. It also comes with the adaptor that...

Order within the next 5 hrs and your part ships today!
$5.14

Screw

Order within the next 5 hrs and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Refrigerator door gasket torn

  • Customer: Matthew from Washington DC
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 121 of 126 people found this instruction helpful
No instructions included, so it took a little bit of staring at the new part to figure out how it works. The barbed ridge on the gasket fits into a slot on the door. The flat face of the gasket has an internal magnetic strip that helps keep the seal tight against the steel face of the refrigerator. Installation requires no tools. This is the basic process:read more

evaporator coil kept freezing up, refridgerator warm.

  • Customer: Greg from Hanover Township PA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 111 of 123 people found this instruction helpful
This was the second part I tried. The defrost timer was first, but that did not fix it. To do this I had to remove the ice maker and the back plate of the freezer. Then I defrosted the coil and cut the wires. stripped them back and installed the new thermostat. re-assembled and tested. has been working great ever since. read more

ICE MAKER STOPPED WORKING

  • Customer: JACK from MESA AZ
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 84 of 90 people found this instruction helpful
IT WAS PRETTY STRAIGHT FORWARD. REMOVE THE TWO SCREWS THAT HOLD THE UNIT TO THE WALL OF THE FREEZER. IN MY CASE, I HAD TO USE A DIFFERENT ICE MAKER THAN WHAT CAME WITH THE FRIG. IN ORDER TO INSTALL THE REPLACEMENT UNIT THEY SENT A WIRE ADAPTOR SO IT WOULD ATTACH TO THE EXISTING WIRING. THAT TOO WAS ALL FINE AND DANDY. THE ONLY PROBLEM WAS THAT THE END O... read more