This is a delta frame surface unit, also known as coil element, for a stove, range, or oven. It is a 6-inch surface burner with a reinforced delta frame that carries 1250 watts and 240 volts. The burn...
$50.86
In Stock
Order within the next 6 hrs and your part ships today!
This trim ring is intended for use with many electric ranges. It is a chrome trim ring that is used with six inch surface burner elements. Notes The matching eight inch chrome trim ring is available w...
$53.89
In Stock
Order within the next 6 hrs and your part ships today!
This is a blower motor for your range, but you may also know it as a blower fan motor or a downdraft vent fan motor. This part is used with down draft models. It helps draw the steam and odors through...
$363.94
In Stock
Order within the next 6 hrs and your part ships today!
This exhaust vent blower wheel is almost seven inches in diameter, and just under four inches deep. It is made entirely of metal and is used with a range's venting system.
$92.66
In Stock
Order within the next 6 hrs and your part ships today!
1. Turn off power to range at circuit breaker 2. Remove grate 3 Remove control knobs 4, Remove two screws holding control panel 5. With wrench, remove locking nuts from control switches 6. Lift panel, exposing switches 7. With new switch in hand, unattach old switch one terminal at a time, attaching new swi
... Read moretch exactly as old switch, terminal by terminal. 8. Replace everything in reverse order 9.Turn on power
Important: Down load the helpful assembly diagram for the fan motor and study it for a few minutes. It's very straight forward. Also a good idea is to remove the bottom panel which comes off easy before starting.
My only problem was removing the existing blower/fan wheel without damaging it once I had the assembly on the work b
... Read moreench. It was rusted on tight and managed to remove after a few tries using penetrating oil. The wheel is in stock and I'd suggest buying a new one along with the new motor if I had to do the job again.
Bottom line; the fan motor fit perfect but did have to re-use part of the old existing electric pig tail because the motor does not come with the factory type motor terminal connectors. By using three twist on wire connectors was back in business. The down draft vent works like new.
